On 5/28/2013 3:06 AM, Tony Lindgren wrote:
* Mugunthan V N <mugunthanvnm@xxxxxx> [130526 11:28]:
From: Hebbar Gururaja <gururaja.hebbar@xxxxxx>
Amend cpsw controller to optionally take a pin control handle and set
the state of the pins to:
- "default" on boot, resume
- "sleep" on suspend()
This should make it possible to optimize energy usage for the pins
for the suspend/resume cycle.
If any of the above pin states are missing in dt, a warning message
about the missing state is displayed.
If certain pin-states are not available, to remove this warning message
pass respective state name with null phandler.
Signed-off-by: Hebbar Gururaja <gururaja.hebbar@xxxxxx>
Signed-off-by: Mugunthan V N <mugunthanvnm@xxxxxx>
---
drivers/net/ethernet/ti/cpsw.c | 48 ++++++++++++++++++++++++++++++++++++++++
1 file changed, 48 insertions(+)
diff --git a/drivers/net/ethernet/ti/cpsw.c b/drivers/net/ethernet/ti/cpsw.c
index 21a5b29..c9ed730 100644
--- a/drivers/net/ethernet/ti/cpsw.c
+++ b/drivers/net/ethernet/ti/cpsw.c
@@ -35,6 +35,7 @@
#include <linux/if_vlan.h>
#include <linux/platform_data/cpsw.h>
+#include <linux/pinctrl/consumer.h>
#include "cpsw_ale.h"
#include "cpts.h"
@@ -351,6 +352,11 @@ struct cpsw_priv {
bool irq_enabled;
struct cpts *cpts;
u32 emac_port;
+
+ /* Two optional pin states - default & sleep */
+ struct pinctrl *pinctrl;
+ struct pinctrl_state *pins_def;
+ struct pinctrl_state *pins_sleep;
};
Which pins do you need to dynamically remux? If it's not all
the pins, you should have three sets: default, active and idle.
This way the static pins in the default group don't need to be
constantly toggled.
Regards,
Tony
Tony
I am using this for all the pins, in probe all the cpsw pins will be
configured
and i have used the same in suspend/resume callback for power saving.
Regards
Mugunthan V N
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
