Tony Lindgren <tony@xxxxxxxxxxx> writes: > * Yegor Yefremov <yegorslists@xxxxxxxxxxxxxx> [130517 14:34]: >> On Fri, May 17, 2013 at 8:56 PM, Mark A. Greer <mgreer@xxxxxxxxxxxxxxx> wrote: >> > On Thu, May 16, 2013 at 12:19:20PM +0200, Yegor Yefremov wrote: >> >> On 15.05.2013 23:50, Mark A. Greer wrote: >> >> > On Wed, May 15, 2013 at 10:07:35AM -0700, Tony Lindgren wrote: >> > >> >> >> Mark, do you have some omap3 with no iva (other than am3703) to test the >> >> >> idle states with? >> >> > >> >> > I have an am35xx which isn't supposed to have an IVA so I can test with it >> >> > (although, I'm not sure how well the kernel works on the am35xx these days). >> >> > >> >> > I'm a bit busy today but I'll try booting the am35xx tomorrow and if it >> >> > comes up, see what I can figure out. >> >> >> >> I think this issue is relevant to am3517 as you can see from this >> >> thread: http://thread.gmane.org/gmane.linux.ports.arm.omap/97903 >> >> I could boot only with your patch http://www.spinics.net/lists/arm-kernel/msg168865.html >> >> >> >> I have such a system running, so if you have any other patches/ideas to test, I would do it. >> > >> > Yegor, since I've so far been unable to get my am3517evm to fire up, can >> > you play around with the 3517 to see if there appears to be iva registers >> > that can be read/written to safely? In particular, can the code that idles >> > the iva be run safely on an am3517? >> >> I'll look into this next week. am3517 and IVA seems to be a really big >> mystery. In the TI forum will be stated, there is no IVA: >> http://e2e.ti.com/support/arm/sitara_arm/f/791/t/150961.aspx, but TRM >> has various appearances of IVA2 registers, but no real >> description/explanation of what is IVA and how to eat it. > > On 3703 it looks like the whole omap3_iva_idle() reset is needed, except > for setting the iva2 bootmode to idle. So I'm planning to merge the following > patch with just comments update this week unless somebody has a better fix > in mind. > > Regards, > > Tony > > > From: Tony Lindgren <tony@xxxxxxxxxxx> > Date: Tue, 14 May 2013 20:28:15 -0700 > Subject: [PATCH] ARM: OMAP3: Fix iva2_pwrdm settings for 3703 > > Commit a819c4f1 (ARM: OMAP3: PM: Only access IVA if one exists) > changed PM to not access IVA registers on omaps that don't have > them. Turns out we still need to idle iva2 as otherwise > iva2_pwrdm will stay on and block deeper idle states. > > It seems that the only part of the reset that may not be needed > is the setting of the iva2 boot mode to idle. But as that register > seems to be there and is harmless if no iva2 is on the SoC, it's > probably safest to do the complete reset. > > Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx> Acked-by: Kevin Hilman <khilman@xxxxxxxxxx> > --- a/arch/arm/mach-omap2/pm34xx.c > +++ b/arch/arm/mach-omap2/pm34xx.c > @@ -546,8 +546,10 @@ static void __init prcm_setup_regs(void) > /* Clear any pending PRCM interrupts */ > omap2_prm_write_mod_reg(0, OCP_MOD, OMAP3_PRM_IRQSTATUS_MPU_OFFSET); > > - if (omap3_has_iva()) > - omap3_iva_idle(); > + /* > + * We need to idle iva2_pwrdm even on am3703 with no iva2. > + */ > + omap3_iva_idle(); > > omap3_d2d_idle(); > } -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
