* Roger Quadros <rogerq@xxxxxx> [130415 04:25]: > On Beagle xM Rev. Ax/Bx, the USB power enable GPIO logic is > reversed when compared to other revisions i.e. it is > active high instead of active low. > > Use the beagle_config.usb_pwr_level flag correctly so that > the power regulator can be configured at runtime. > > Signed-off-by: Roger Quadros <rogerq@xxxxxx> Thanks applying into omap-for-v3.10/fixes. Regards, Tony > --- > arch/arm/mach-omap2/board-omap3beagle.c | 6 +++--- > 1 files changed, 3 insertions(+), 3 deletions(-) > > diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c > index 5382215..21136b2 100644 > --- a/arch/arm/mach-omap2/board-omap3beagle.c > +++ b/arch/arm/mach-omap2/board-omap3beagle.c > @@ -112,13 +112,13 @@ static u8 omap3_beagle_version; > */ > static struct { > int mmc1_gpio_wp; > - int usb_pwr_level; > + bool usb_pwr_level; /* 0 - Active Low, 1 - Active High */ > int dvi_pd_gpio; > int usr_button_gpio; > int mmc_caps; > } beagle_config = { > .mmc1_gpio_wp = -EINVAL, > - .usb_pwr_level = GPIOF_OUT_INIT_LOW, > + .usb_pwr_level = 0, > .dvi_pd_gpio = -EINVAL, > .usr_button_gpio = 4, > .mmc_caps = MMC_CAP_4_BIT_DATA | MMC_CAP_8_BIT_DATA, > @@ -178,7 +178,7 @@ static void __init omap3_beagle_init_rev(void) > case 0: > printk(KERN_INFO "OMAP3 Beagle Rev: xM Ax/Bx\n"); > omap3_beagle_version = OMAP3BEAGLE_BOARD_XM; > - beagle_config.usb_pwr_level = GPIOF_OUT_INIT_HIGH; > + beagle_config.usb_pwr_level = 1; > beagle_config.mmc_caps &= ~MMC_CAP_8_BIT_DATA; > break; > case 2: > -- > 1.7.4.1 > -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html