PHY reset GPIO handling will be done in the PHY driver Signed-off-by: Roger Quadros <rogerq@xxxxxx> Acked-by: Felipe Balbi <balbi@xxxxxx> Acked-by: Samuel Ortiz <sameo@xxxxxxxxxxxxxxx> --- drivers/mfd/omap-usb-host.c | 28 ---------------------------- 1 files changed, 0 insertions(+), 28 deletions(-) diff --git a/drivers/mfd/omap-usb-host.c b/drivers/mfd/omap-usb-host.c index eb5db28..138ee98 100644 --- a/drivers/mfd/omap-usb-host.c +++ b/drivers/mfd/omap-usb-host.c @@ -430,24 +430,10 @@ static unsigned omap_usbhs_rev2_hostconfig(struct usbhs_hcd_omap *omap, static void omap_usbhs_init(struct device *dev) { struct usbhs_hcd_omap *omap = dev_get_drvdata(dev); - struct usbhs_omap_platform_data *pdata = omap->pdata; unsigned reg; dev_dbg(dev, "starting TI HSUSB Controller\n"); - if (pdata->phy_reset) { - if (gpio_is_valid(pdata->reset_gpio_port[0])) - devm_gpio_request_one(dev, pdata->reset_gpio_port[0], - GPIOF_OUT_INIT_LOW, "USB1 PHY reset"); - - if (gpio_is_valid(pdata->reset_gpio_port[1])) - devm_gpio_request_one(dev, pdata->reset_gpio_port[1], - GPIOF_OUT_INIT_LOW, "USB2 PHY reset"); - - /* Hold the PHY in RESET for enough time till DIR is high */ - udelay(10); - } - pm_runtime_get_sync(dev); reg = usbhs_read(omap->uhh_base, OMAP_UHH_HOSTCONFIG); @@ -476,20 +462,6 @@ static void omap_usbhs_init(struct device *dev) dev_dbg(dev, "UHH setup done, uhh_hostconfig=%x\n", reg); pm_runtime_put_sync(dev); - if (pdata->phy_reset) { - /* Hold the PHY in RESET for enough time till - * PHY is settled and ready - */ - udelay(10); - - if (gpio_is_valid(pdata->reset_gpio_port[0])) - gpio_set_value_cansleep - (pdata->reset_gpio_port[0], 1); - - if (gpio_is_valid(pdata->reset_gpio_port[1])) - gpio_set_value_cansleep - (pdata->reset_gpio_port[1], 1); - } } /** -- 1.7.4.1 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html