* Paul Walmsley <paul@xxxxxxxxx> [121112 11:33]: > > Here are some basic OMAP test results for Linux v3.7-rc5. > Logs and other details at: > > http://www.pwsan.com/omap/testlogs/test_v3.7-rc5/20121111081034/ > > > Passing tests > ------------- > > Boot to userspace (9/11): 2420n800, 2430sdp, 3517evm, 3530es3beagle, > 3730beaglexm, 37xxevm, 4430es2panda, 5912osk, am335xbone > > PM ret/off, suspend + dynamic idle (2/4): 3730beaglexm, 37xxevm > > > Failing tests: fixed by posted patches > -------------------------------------- > > Boot tests: > > * 3530ES3 Beagle: I2C timeouts during userspace init > - Intermittent, appears on 5 out of 6 boots here > - Aaro Koskinen observes this also on N900 > - Appears to be caused by commit 3db11feffc1ad2ab9dea27789e6b5b3032827adc > - http://marc.info/?l=linux-arm-kernel&m=135071372426971&w=2 > - http://marc.info/?l=linux-omap&m=135197877112220&w=2 > - Revert posted, pending I2C maintainers: > - http://marc.info/?l=linux-arm-kernel&m=135221953727077&w=2 Here's one more booting issue I recently ran into: - If DEBUG_LL and earlyprintk are enabled, and omap-serial.c is compiled as a module, the kernel boot hangs early as the clocks for serial port are cut while earlyprintk still uses the port. This might be regression from v3.6. > PM tests: > > * 3530es3beagle: hangs during off-mode dynamic idle test > - Appears to be caused by commit 6c31b2150ff96755d24e0ab6d6fea08a7bf5c44c: > - http://marc.info/?l=linux-omap&m=135075364705188&w=2 > - Fixed by http://www.spinics.net/lists/arm-kernel/msg202116.html > > Other: > > * 2420N800: powers down 30 seconds after boot > - Presumably due to missing CBUS patches for watchdog control > - http://lkml.org/lkml/2012/9/3/265 > > * 4430es2panda: omap_hwmod: mcpdm: cannot be enabled for reset (3) > - clock source is from an external I2C-controlled source > - must skip reset until the switchover to hwmod late init > - http://www.spinics.net/lists/arm-kernel/msg178138.html > > > Failing tests: needing investigation > ------------------------------------ > > Boot tests: > > * CM-T3517: L3 in-band error with IPSS during boot > - Cause unknown but see http://marc.info/?l=linux-omap&m=134833869730129&w=2 > - Longstanding issue; does not occur on the 3517EVM > > * 3517EVM & CM-T3517: boot hangs with NFS root > - Likely some Kconfig, board file, and PM issues with EMAC > > * CM-T3517: boot hangs with MMC boot > - Due to missing MMC setup in board file > > Other: > > * 4430es2panda: omap_hwmod: l3_instr: _wait_target_disable failed > - Unknown cause; could be due to the lack of hierarchical enable/disable > in hwmod code > - Jon Hunter reports this does not appear with the same X-loader/bootloader > on his 4430ES2.3 Panda, so could be ES-level dependent > > > Failing tests: needing local investigation (may be due to testbed issues) > ------------------------------------------------------------------------- > > Boot tests: > > * AM335x Beaglebone: omap2plus_defconfig kernels don't boot > - May be fixed now, pending retest: > - http://marc.info/?l=linux-omap&m=135082257727502&w=2 > - Not yet part of the automated test suite > * May be due to an old U-boot with FDT support problems used here? > Pending local investigation and re-test > > * 4460pandaes: boot fails early > - Appears to be due to X-loader problems here > - Need to note the X-loader version so we know it's broken > > PM tests: > > * 3730 Beagle XM: does not serial wake from off-idle suspend when console > UART doesn't clock gate ("debug ignore_loglevel") > - Not shown in the current test logs; cause unknown > - Pending re-test > > > vmlinux object size > (delta in bytes from test_v3.7-rc4 (3d70f8c617a436c7146ecb81df2265b4626dfe89)): > text data bss total kernel > +500 -8 0 +492 am33xx_only > +456 +16 0 +472 n800_multi_omap2xxx > +424 +16 0 +440 n800_only_a > +164 0 0 +164 omap1_defconfig > +164 0 0 +164 omap1_defconfig_1510innovator_only > +164 0 0 +164 omap1_defconfig_5912osk_only > +940 -8 0 +932 omap2plus_defconfig > +796 -8 0 +788 omap2plus_defconfig_2430sdp_only > +940 +24 0 +964 omap2plus_defconfig_cpupm > +940 -8 0 +932 omap2plus_defconfig_no_pm > +940 +16 0 +956 omap2plus_defconfig_omap2_4_only > +820 +16 0 +836 omap2plus_defconfig_omap3_4_only > +20 +8 +48 +76 rmk_omap3430_ldp_allnoconfig > +124 0 0 +124 rmk_omap3430_ldp_oldconfig > +20 +8 +48 +76 rmk_omap4430_sdp_allnoconfig > +124 +8 0 +132 rmk_omap4430_sdp_oldconfig > > > - Paul > > -- > To unsubscribe from this list: send the line "unsubscribe linux-omap" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
