On Tuesday 06 November 2012 10:22 PM, Venkatraman S wrote:
Define the most frequently used bitmasks of the Interrupt Enable /
Interrupt Status register with consistent naming ( with _EN suffix).
Use meaningful concatenation of bitfields for INT_EN_MASK, which shows
which interrupts are enabled by default.
No functional changes.
Signed-off-by: Venkatraman S <svenkatr@xxxxxx>
Hi Venkat,
Not sure if you had chance to look into my comments on Version 2 of this
patch
Acked-by: Felipe Balbi <balbi@xxxxxx>
---
drivers/mmc/host/omap_hsmmc.c | 54 +++++++++++++++++++++++++------------------
1 file changed, 31 insertions(+), 23 deletions(-)
diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
index e91e85a..d16ef0f 100644
--- a/drivers/mmc/host/omap_hsmmc.c
+++ b/drivers/mmc/host/omap_hsmmc.c
@@ -80,29 +80,17 @@
#define CLKD_SHIFT 6
#define DTO_MASK 0x000F0000
#define DTO_SHIFT 16
-#define INT_EN_MASK 0x307F0033
-#define BWR_ENABLE (1 << 4)
-#define BRR_ENABLE (1 << 5)
-#define DTO_ENABLE (1 << 20)
#define INIT_STREAM (1 << 1)
#define DP_SELECT (1 << 21)
#define DDIR (1 << 4)
-#define DMA_EN 0x1
+#define DMAE 0x1
This change is not needed or may not be part of this patch.
#define MSBS (1 << 5)
#define BCE (1 << 1)
#define FOUR_BIT (1 << 1)
#define HSPE (1 << 2)
#define DDR (1 << 19)
#define DW8 (1 << 5)
-#define CC 0x1
-#define TC 0x02
#define OD 0x1
-#define ERR (1 << 15)
-#define CMD_TIMEOUT (1 << 16)
-#define DATA_TIMEOUT (1 << 20)
-#define CMD_CRC (1 << 17)
-#define DATA_CRC (1 << 21)
-#define CARD_ERR (1 << 28)
#define STAT_CLEAR 0xFFFFFFFF
#define INIT_STREAM_CMD 0x00000000
#define DUAL_VOLT_OCR_BIT 7
@@ -111,6 +99,26 @@
#define SOFTRESET (1 << 1)
#define RESETDONE (1 << 0)
+/* Interrupt masks for IE and ISE register */
+#define CC_EN (1 << 0)
+#define TC_EN (1 << 1)
You might want to retain CC, TC ... which has been defined and already
used for in many places for MMCHS_STAT instead of CC_EN. CC_EN is not
mentioned in TRM however CC is defined as bit field in TRM Register spec.
So It would be better to reuse the previously defined CC, TC (and other
bits fields) for MMCHS_IE, MMCHS_ISE inorder to reduce the number of
#define's.
+#define BWR_EN (1 << 4)
+#define BRR_EN (1 << 5)
+#define ERR_EN (1 << 15)
ERR_EN is not applicable for Interrupt masks for IE and ISE register
+#define CTO_EN (1 << 16)
+#define CCRC_EN (1 << 17)
+#define CEB_EN (1 << 18)
+#define CIE_EN (1 << 19)
+#define DTO_EN (1 << 20)
+#define DCRC_EN (1 << 21)
+#define DEB_EN (1 << 22)
+#define CERR_EN (1 << 28)
+#define BADA_EN (1 << 29)
+
+#define INT_EN_MASK (BADA_EN | CERR_EN | DEB_EN | DCRC_EN |\
+ DTO_EN | CIE_EN | CEB_EN | CCRC_EN | CTO_EN | ERR_EN |\
+ BRR_EN | BWR_EN | TC_EN | CC_EN)
+
#define MMC_AUTOSUSPEND_DELAY 100
#define MMC_TIMEOUT_MS 20
#define OMAP_MMC_MIN_CLOCK 400000
@@ -458,13 +466,13 @@ static void omap_hsmmc_enable_irq(struct omap_hsmmc_host *host,
unsigned int irq_mask;
if (host->use_dma)
- irq_mask = INT_EN_MASK & ~(BRR_ENABLE | BWR_ENABLE);
+ irq_mask = INT_EN_MASK & ~(BRR_EN | BWR_EN);
else
irq_mask = INT_EN_MASK;
/* Disable timeout for erases */
if (cmd->opcode == MMC_ERASE)
- irq_mask &= ~DTO_ENABLE;
+ irq_mask &= ~DTO_EN;
OMAP_HSMMC_WRITE(host->base, STAT, STAT_CLEAR);
OMAP_HSMMC_WRITE(host->base, ISE, irq_mask);
@@ -702,8 +710,8 @@ static void send_init_stream(struct omap_hsmmc_host *host)
OMAP_HSMMC_WRITE(host->base, CMD, INIT_STREAM_CMD);
timeout = jiffies + msecs_to_jiffies(MMC_TIMEOUT_MS);
- while ((reg != CC) && time_before(jiffies, timeout))
- reg = OMAP_HSMMC_READ(host->base, STAT) & CC;
+ while ((reg != CC_EN) && time_before(jiffies, timeout))
+ reg = OMAP_HSMMC_READ(host->base, STAT) & CC_EN;
By reusing already defined bit fields documented in TRM,
this change and other changes below will not be needed thereby keeping
the patch smaller with less changes and yet removing the magic bit mask
numbers
OMAP_HSMMC_WRITE(host->base, CON,
OMAP_HSMMC_READ(host->base, CON) & ~INIT_STREAM);
@@ -794,7 +802,7 @@ omap_hsmmc_start_command(struct omap_hsmmc_host *host, struct mmc_command *cmd,
}
if (host->use_dma)
- cmdreg |= DMA_EN;
+ cmdreg |= DMAE;
DMA_EN for DMA enable is much more readable than DMAE.
host->req_in_progress = 1;
@@ -1014,11 +1022,11 @@ static void omap_hsmmc_do_irq(struct omap_hsmmc_host *host, int status)
data = host->data;
dev_vdbg(mmc_dev(host->mmc), "IRQ Status is %x\n", status);
- if (status & ERR) {
+ if (status & ERR_EN) {
ERR can be retained.
This change will not be needed.
omap_hsmmc_dbg_report_irq(host, status);
- if (status & (CMD_TIMEOUT | DATA_TIMEOUT))
+ if (status & (CTO_EN | DTO_EN))
If you really want to use uniform naming you can rename CMD_TIMEOUT,
DATA_TIMEOUT to CTO, DTO ....
hsmmc_command_incomplete(host, -ETIMEDOUT);
- else if (status & (CMD_CRC | DATA_CRC))
+ else if (status & (CCRC_EN | DCRC_EN))
hsmmc_command_incomplete(host, -EILSEQ);
if (host->cmd)
@@ -1029,9 +1037,9 @@ static void omap_hsmmc_do_irq(struct omap_hsmmc_host *host, int status)
}
}
- if (end_cmd || ((status & CC) && host->cmd))
+ if (end_cmd || ((status & CC_EN) && host->cmd))
CC can be retained.
This change will not be needed.
omap_hsmmc_cmd_done(host, host->cmd);
- if ((end_trans || (status & TC)) && host->mrq)
+ if ((end_trans || (status & TC_EN)) && host->mrq)
TC can be retained.
This change will not be needed.
omap_hsmmc_xfer_done(host, data);
}
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html