In 16bit NAND mode the GPMC would send the command 0xNN as 0xFFNN
instead of 0x00NN on the bus. The 0xFFs were actually uninitialized
bits that were left unset in the GPMC command output register. The
reason they weren't initialized in 16bit mode is that if the same code
that writes to this register was used in 8bit mode then 2 commands
would be output in 8bit mode. One for the low byte, and an extra 0x0
command for the high byte. This commit uses writew if we're using
16bit NAND.
Most chips seem fine with the extra 0xFFs, but the ONFI spec says
otherwise.
Signed-off-by: Christopher Harvey <charvey@xxxxxxxxxx>
---
drivers/mtd/nand/omap2.c | 14 +++++++++-----
1 files changed, 9 insertions(+), 5 deletions(-)
diff --git a/drivers/mtd/nand/omap2.c b/drivers/mtd/nand/omap2.c
index 5c8978e..6e1c1e5 100644
--- a/drivers/mtd/nand/omap2.c
+++ b/drivers/mtd/nand/omap2.c
@@ -232,16 +232,20 @@ static void omap_hwcontrol(struct mtd_info *mtd, int cmd, unsigned int ctrl)
{
struct omap_nand_info *info = container_of(mtd,
struct omap_nand_info, mtd);
+ void __iomem *reg;
if (cmd != NAND_CMD_NONE) {
if (ctrl & NAND_CLE)
- writeb(cmd, info->reg.gpmc_nand_command);
-
+ reg = info->reg.gpmc_nand_command;
else if (ctrl & NAND_ALE)
- writeb(cmd, info->reg.gpmc_nand_address);
-
+ reg = info->reg.gpmc_nand_address;
else /* NAND_NCE */
- writeb(cmd, info->reg.gpmc_nand_data);
+ reg = info->reg.gpmc_nand_data;
+
+ if (info->nand.options & NAND_BUSWIDTH_16)
+ writew(cmd, reg);
+ else
+ writeb(cmd, reg);
}
}
--
1.7.8.6
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
