RACEN bit should only be set if the voltage and command register addresses are the same. Signed-off-by: Tero Kristo <t-kristo@xxxxxx> --- arch/arm/mach-omap2/vc.c | 5 ++++- 1 files changed, 4 insertions(+), 1 deletions(-) diff --git a/arch/arm/mach-omap2/vc.c b/arch/arm/mach-omap2/vc.c index 2ca00bc..a63c53a 100644 --- a/arch/arm/mach-omap2/vc.c +++ b/arch/arm/mach-omap2/vc.c @@ -695,9 +695,12 @@ void __init omap_vc_init_channel(struct voltagedomain *voltdm) voltdm->rmw(vc->smps_cmdra_mask, vc->cmd_reg_addr << __ffs(vc->smps_cmdra_mask), vc->smps_cmdra_reg); - vc->cfg_channel |= vc_cfg_bits->rac | vc_cfg_bits->racen; + vc->cfg_channel |= vc_cfg_bits->rac; } + if (vc->cmd_reg_addr == vc->volt_reg_addr) + vc->cfg_channel |= vc_cfg_bits->racen; + /* Set up the on, inactive, retention and off voltage */ on_vsel = omap_vc_calc_vsel(voltdm, voltdm->vc_param->on); onlp_vsel = omap_vc_calc_vsel(voltdm, voltdm->vc_param->onlp); -- 1.7.4.1 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
