Hello Wolfram,
When booting using a device tree, the adapter number is dynamically
assigned after the log message is sent.
This patch modifies the log message to get a correct adapter id.
Applies on 3.6-rc3. Tested on OMAP3 (Gumstix Overo).
Thanks for the fix. Tested successfully on OMAP4 SDP DT boot as well.
[ 0.000000] Linux version 3.6.0-rc3-00030-g491038d (bcousson@lnwes3201) (gcc version 4.5.2 (Sourcery G++ Lite 2011.03-41) ) #6 SMP Fri Aug 31 13:50:48 CEST 2012
[ 0.000000] CPU: ARMv7 Processor [411fc092] revision 2 (ARMv7), cr=10c53c7d
[ 0.000000] CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
[ 0.000000] Machine: Generic OMAP4 (Flattened Device Tree), model: TI OMAP4 SDP board
...
[ 0.667205] omap_i2c i2c.15: bus 0 rev2.4.0 at 400 kHz
...
[ 0.768341] omap_i2c i2c.16: bus 1 rev2.4.0 at 400 kHz
[ 0.783905] omap_i2c i2c.17: bus 2 rev2.4.0 at 400 kHz
[ 0.799530] omap_i2c i2c.18: bus 3 rev2.4.0 at 400 kHz
Signed-off-by: Florian Vaussard <florian.vaussard@xxxxxxx>
Tested-by: Benoit Cousson <b-cousson@xxxxxx>
and
Acked-by: Benoit Cousson <b-cousson@xxxxxx>
Regards,
Benoit
Was this patch picked-up by the i2c-embedded subsystem?
Thank you.
Regards,
Florian
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
