Hi Sourav,
While rebasing your series on top of Tony's lo/devel-dt, I realized that the keypad nodes are not located at the correct place :-(
At the moment they are just floating at the top level of the dts while they belong to the ocp bus and thus should be put there.
I fixed that since it was trivial and cleaned as well the changelog and the comments to aligned then properly. I added as well the physical address to the node name and a label for easy reference at board level.
I did some basic test on my OMAP4 sdp, but that all I can do so far.
Could you just check if this is still fine for OMAP5 before I ask Tony to pull that.
I based that on top of Tony's DT patches due to conflict with the existing MMC patch in it.
The following changes since commit 85d7ff9b907685b6469058888f1d961b3e8d47ad:
Olof Johansson (1):
ARM: omap: add dtb targets
are available in the git repository at:
git://git.kernel.org/pub/scm/linux/kernel/git/bcousson/linux-omap-dt.git for_3.7/dts
Sourav Poddar (6):
arm/dts: omap5-evm: Add I2C support
arm/dts: omap5-evm: Add tmp102 sensor support
arm/dts: omap5-evm: Add keypad data
arm/dts: omap5-evm: Add bmp085 sensor support
arm/dts: omap4-sdp: Add keypad data
Documentation: dt: i2c: trivial-devices: Update for tmp102
.../devicetree/bindings/i2c/trivial-devices.txt | 1 +
arch/arm/boot/dts/omap4-sdp.dts | 70 ++++++++++++++++++++
arch/arm/boot/dts/omap4.dtsi | 5 ++
arch/arm/boot/dts/omap5-evm.dts | 33 +++++++++
arch/arm/boot/dts/omap5.dtsi | 40 +++++++++++
5 files changed, 149 insertions(+), 0 deletions(-)
Regards,
Benoit
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
