On Sun, Aug 26, 2012 at 3:53 PM, NeilBrown <neilb@xxxxxxx> wrote:
>
> On Sun, 26 Aug 2012 09:47:50 +0530 "Shilimkar, Santosh"
> <santosh.shilimkar@xxxxxx> wrote:
>
> > + Jon,
> >
> > On Sat, Aug 25, 2012 at 5:14 PM, NeilBrown <neilb@xxxxxxx> wrote:
> > >
> > >
> > >
> > > Current kernel will wake from suspend on an event on any active
> > > GPIO even if enable_irq_wake() wasn't called.
> > >
> > > There are two reasons that the hardware wake-enable bit should be set:
> > >
> > > 1/ while non-suspended the CPU might go into a deep sleep (off_mode)
> > > in which the wake-enable bit is needed for an interrupt to be
> > > recognised.
> > > 2/ while suspended the GPIO interrupt should wake from suspend if and
> > > only if irq_wake as been enabled.
> > >
> > > The code currently doesn't keep these two reasons separate so they get
> > > confused and sometimes the wakeup flags is set incorrectly.
> > >
> > > This patch reverts:
> > > commit 9c4ed9e6c01e7a8bd9079da8267e1f03cb4761fc
> > > gpio/omap: remove suspend/resume callbacks
> > > and
> > > commit 0aa2727399c0b78225021413022c164cb99fbc5e
> > > gpio/omap: remove suspend_wakeup field from struct gpio_bank
> > >
> > > and makes some minor changes so that we have separate flags for "GPIO
> > > should wake from deep idle" and "GPIO should wake from suspend".
> > >
> > > With this patch, the GPIO from my touch screen doesn't wake my device
> > > any more, which is what I want.
> > >
> > > Cc: Kevin Hilman <khilman@xxxxxx>
> > > Cc: Tony Lindgren <tony@xxxxxxxxxxx>
> > > Cc: Santosh Shilimkar <santosh.shilimkar@xxxxxx>
> > > Cc: Cousson, Benoit <b-cousson@xxxxxx>
> > > Cc: Grant Likely <grant.likely@xxxxxxxxxxxx>
> > > Cc: Tarun Kanti DebBarma <tarun.kanti@xxxxxx>
> > > Cc: Felipe Balbi <balbi@xxxxxx>
> > > Cc: Govindraj.R <govindraj.raja@xxxxxx>
> > >
> > > Signed-off-by: NeilBrown <neilb@xxxxxxx>
> > >
> > The patch doesn't seems to be correct. At least the 2/ gets
> > fixed with a proper IRQCHIP flag. Can you try the patch at
> > end of the email and see if it helps ? Am attaching it in case
> > mailer damages it.
> >
> > Regards
> > Santosh
> >
> > >From b8a38fc75e046f6462610e26c47c620cad850c24 Mon Sep 17 00:00:00 2001
> > From: Santosh Shilimkar <santosh.shilimkar@xxxxxx>
> > Date: Sun, 26 Aug 2012 09:39:51 +0530
> > Subject: [PATCH] gpio: omap: Set IRQCHIP_MASK_ON_SUSPEND to mask all
> > non-wakeup gpio wakeups.
> >
> > Set the irq chip flag IRQCHIP_MASK_ON_SUSPEND to cause the irq pm code
> > to mask all non-wake gpios in suspend, which will ensure the wakeup
> > enable
> > bit is not set on non-wake gpios.
> >
> > Signed-off-by: Santosh Shilimkar <santosh.shilimkar@xxxxxx>
> > ---
> > drivers/gpio/gpio-omap.c | 1 +
> > 1 file changed, 1 insertion(+)
> >
> > diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
> > index e6efd77..50b4c18 100644
> > --- a/drivers/gpio/gpio-omap.c
> > +++ b/drivers/gpio/gpio-omap.c
> > @@ -779,6 +779,7 @@ static struct irq_chip gpio_irq_chip = {
> > .irq_unmask = gpio_unmask_irq,
> > .irq_set_type = gpio_irq_type,
> > .irq_set_wake = gpio_wake_enable,
> > + .flags = IRQCHIP_MASK_ON_SUSPEND;
> > };
> >
> >
> > /*---------------------------------------------------------------------*/
>
>
> No obvious damage, unless the mailer is responsible or the ';' at the end
> of
> the line, rather than ',' :-)
>
:-) That was typo.
> The approach makes sense, but does actually work. Should be fixable
> though.
>
> When I try this I get:
>
>
>
> [ 158.114440] Checking wakeup interrupts
> [ 158.118408] Unhandled fault: external abort on non-linefetch (0x1028)
> at 0xfb054040
> [ 158.126403] Internal error: : 1028 [#1] PREEMPT ARM
> [ 158.131500] Modules linked in: ipv6 g_ether hso libertas_sdio libertas
> cfg80211
> [ 158.139190] CPU: 0 Not tainted (3.5.0-gta04-debug+ #2)
> [ 158.144927] PC is at _set_gpio_triggering+0x38/0x258
> [ 158.150115] LR is at gpio_mask_irq+0xac/0xc0
> [ 158.154602] pc : [<c01d24a0>] lr : [<c01d2f68>] psr: 60000193
> [ 158.154602] sp : db521e90 ip : 00000011 fp : beeecc2c
> [ 158.166595] r10: c05c8ebc r9 : daa5a858 r8 : 00000003
> [ 158.172027] r7 : a0000193 r6 : 00000000 r5 : fb054000 r4 : ded44e18
> [ 158.178863] r3 : 00000001 r2 : 00000000 r1 : ded30340 r0 : 00000040
> [ 158.185668] Flags: nZCv IRQs off FIQs on Mode SVC_32 ISA ARM
> Segment use
>
> so it looks like runtime PM has turned off the iclk to the GPIO module so
> that
> when we try to tell it to change settings, it is no longer listening to
> us.
>From the crash logs it appears like that.
> The "Checking wakeup interrupts" function happens very late in the suspend
> cycle, after all the suspend_late and suspend_noirq functions have run.
> Maybe it needs to be moved earlier...
>
No it shouldn't be moved and it is that point for lot many good
reasons. Ofcourse
this omap gpio driver crash needs to be addressed. Need to think bit
more on this
issue.
Regards
Santosh
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
