Hi Paul, On Thu, Jun 28, 2012 at 22:02:46, Paul Walmsley wrote: > On Thu, 28 Jun 2012, Bedia, Vaibhav wrote: > > > On Thu, Jun 28, 2012 at 21:22:54, Paul Walmsley wrote: > > [...] > > > > > > dma_mask and coherent_dma_mask can be specified during > > > device creation. See usb_musb_init() in arch/arm/mach-omap2/usb-musb.c > > > for an example. > > > > > > > Thanks for pointing this out. Should omap_device_build() start handling this > > or would that be an overkill? > > If both dma_mask and coherent_dma_mask are always 0xffffffff on all OMAPs > and we can set that safely even for devices that don't use it, then yeah > it sounds like we should set it. > > Care to send a patch? > I just grepped for the any other user of this under mach-omap2 and plat-omap and there are a few other places where it's getting used. All of them are setting it to 0xffffffff and same is the case with the CPSW driver. I don't know much about the dma stuff so I am bit reluctant in setting this unconditionally. I looked at setting the mask based on a flag during omap_device_build() but an additional flag in the API will cause all the users to be changed. We could perhaps extend the omap_hwmod structure for passing on this information. Or for CPSW we could stick with approach that's been adopted in usb_musb_init(). Which approach sounds better to you? Regards, Vaibhav B. -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
