On Fri, Apr 27, 2012 at 03:25:38PM -0700, Kevin Hilman wrote: > "Mark A. Greer" <mgreer@xxxxxxxxxxxxxxx> writes: > > > On Thu, Apr 26, 2012 at 04:29:45PM -0700, Kevin Hilman wrote: > > > > Hi Kevin. > > > >> This is a rebased version of this series which is ready for broader > >> testing. I'd especially appreciate testing from those of you with > >> AM35x platforms. > >> > >> Currently, our SoC detection is based on SoC family detection > >> (using die ID) and the presence of specific IP blocks (or feature.) > >> > >> This series begins the separation of the SoC family detection and > >> specific IP detection by completely removing IP detection from the SoC > >> family detection (cpu_is_*.) > >> > >> Applies on top of v3.4-rc4, boot tested on AM3517 EVM. > > > > Your series applied and booted without issue until the point that > > pm_idle is called. At that point it hung because its doing a wfi > > and not getting an interrupt to wake up back up. That's expected > > behaviour so your patches are good (IMHO) but I need to finish and > > submit a new version of my patches to fix that issue. > > For the benefit of others wanting to test this: > > You have to use 'nohlt' on the cmdline on AM35x in order to avoid WFI > and the wakeup problems that are still being worked on. > > Kevin > -- > To unsubscribe from this list: send the line "unsubscribe linux-omap" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html Hello Kevin, I have a Logic PD AM3517 Zoom Experimenter [SOMAM3517-10-1780RJXR-C (REV A)]. My board booted to the Linux login on MMC rootfs. The following is from 'dmesg' output: [start]----------------------------------------------------------------- ... [ 0.000000] Kernel command line: console=ttyO2,115200n8 root=/dev/mmcblk0p2 rw nohlt rootfstype=ext3 rootwait omapdss.def_disp=dvi omapfb.mode=dvi:1280x800@60 ... [ 0.107727] omap_hwmod: am35x_otg_hs: cannot be enabled (3) [ 0.121704] omap_hwmod: uart4: softreset failed (waited 10000 usec) ... [ 0.136505] ------------[ cut here ]------------ [ 0.136566] WARNING: at /sandbox/linux/arch/arm/mach-omap2/pm.c:48 _init_omap_device+0x74/0x94() [ 0.136566] _init_omap_device: could not find omap_hwmod for iva [ 0.136596] Modules linked in: [ 0.136657] [<c001855c>] (unwind_backtrace+0x0/0x11c) from [<c0032540>] (warn_slowpath_common+0x4c/0x64) [ 0.136718] [<c0032540>] (warn_slowpath_common+0x4c/0x64) from [<c00325d8>] (warn_slowpath_fmt+0x2c/0x3c) [ 0.136749] [<c00325d8>] (warn_slowpath_fmt+0x2c/0x3c) from [<c0649b80>] (_init_omap_device+0x74/0x94) [ 0.136779] [<c0649b80>] (_init_omap_device+0x74/0x94) from [<c0649bd4>] (omap2_common_pm_init+0x34/0x5c) [ 0.136810] [<c0649bd4>] (omap2_common_pm_init+0x34/0x5c) from [<c0008644>] (do_one_initcall+0x90/0x164) [ 0.136840] [<c0008644>] (do_one_initcall+0x90/0x164) from [<c06418c4>] (kernel_init+0x120/0x1dc) [ 0.136901] [<c06418c4>] (kernel_init+0x120/0x1dc) from [<c00136e8>] (kernel_thread_exit+0x0/0x8) [ 0.137207] ---[ end trace 1b75b31a2719ed1c ]--- ... [ 0.184143] dpll3_m2_clk rate change failed: -22 [ 0.186218] usbhs_omap: alias fck already exists [ 0.191223] _omap_mux_init_gpio: Multiple gpio paths (2) for gpio126 ... [ 0.547546] usbhs_omap usbhs_omap: xclk60mhsp1_ck set parentfailed error:-22 [ 0.547607] usbhs_omap usbhs_omap: xclk60mhsp2_ck set parentfailed error:-22 ... [ 0.858215] omapdss_venc supply vdda_dac not found, using dummy regulator [ e.863067] omapdss supply vdds_dsi not found, using dummy regulator ... [ 1.864593] davinci_mdio davinci_mdio.0: davinci mdio revision 1.5 [ 1.871093] davinci_mdio davinci_mdio.0: detected phy mask fffffffe [ 1.881072] davinci_mdio.0: probed [ 1.884643] davinci_mdio davinci_mdio.0: phy[0]: device davinci_mdio-0:00, driver SMSC LAN8710/LAN8720 ... [ 4.477539] voltdm_scale: No voltage scale API registered for vdd_mpu_iva [ 4.484832] voltdm_scale: No voltage scale API registered for vdd_core ... [ 4.569549] omapfb omapfb: failed to allocate fbmem [ 4.579437] omapfb omapfb: failed to setup omapfb [ 4.588745] omapfb: probe of omapfb failed with error -12 [end]------------------------------------------------------------------- Mark Greer's patches from earlier this month helped with some of these IVA related items. I would like to help test some of the AM3517 changes. I have two SOMAM3517 cards (one with WiFi). Is there a kernel config that is commonly used by those testing the AM3517? or modified omap2plus? I think some issues that I am seeing involve wrong configuration assumptions by me. -- Derald D. Woods -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
