Hi, I'm testing v3.3-rc1 on OMAP3 overo, and I'm having problems probably related to PM. First, when I boot up, the console (via USB serial) is very laggy, it often takes many seconds until the key pressed appears so it's more or less unusable. Second, I compile DSS as modules, and don't load them. Looking at debugfs/pm_debug/time, I can see that both RET and ON for dss_pwrdm are increasing. What is making DSS powerdomain switch back and forth? Third, when I load the DSS modules, I see only ON state increasing for dss_pwrdm, as it should be. However, I'm getting constant stream of sync losts from DSS, and the display doesn't basically work at all. I can see MPU pwrdm going into RET a lot, and if I do "while true; do echo foo; done", which I presume basically prevents RET for MPU, the display becomes stable. This sounds a bit like the problem reported by Joe (DSS2/PM on 3.2 broken?), although this is happening all the time. In this case, as in Joe's, the DSS fck is well below 96MHz, which is the limit on OMAP3 for DSS fclk on OPP2. And I'm not aware of any other constraints for DSS (well, memory throughput, but that should cause fifo underflows). Is there a way to lock the OPP to the full power OPP? Is there a way to see the OPP being used? Tomi
Attachment:
signature.asc
Description: This is a digitally signed message part
