EMIF - External Memory Interface - is an SDRAM controller used in
TI SoCs. EMIF supports, based on the IP revision, one or more of
DDR2/DDR3/LPDDR2 protocols. This binding describes a given instance
of the EMIF IP and memory parts attached to it.
Cc: Rajendra Nayak <rnayak@xxxxxx>
Cc: Benoit Cousson <b-cousson@xxxxxx>
Cc: Olof Johansson <olof@xxxxxxxxx>
Signed-off-by: Aneesh V <aneesh@xxxxxx>
---
Changes in RFC v3:
* Fixed review comments from RFC v2
---
.../bindings/memory-controllers/ti/emif.txt | 49 ++++++++++++++++++++
1 files changed, 49 insertions(+), 0 deletions(-)
create mode 100644 Documentation/devicetree/bindings/memory-controllers/ti/emif.txt
diff --git a/Documentation/devicetree/bindings/memory-controllers/ti/emif.txt b/Documentation/devicetree/bindings/memory-controllers/ti/emif.txt
new file mode 100644
index 0000000..2925add
--- /dev/null
+++ b/Documentation/devicetree/bindings/memory-controllers/ti/emif.txt
@@ -0,0 +1,49 @@
+* EMIF family of TI SDRAM controllers
+
+EMIF - External Memory Interface - is an SDRAM controller used in
+TI SoCs. EMIF supports, based on the IP revision, one or more of
+DDR2/DDR3/LPDDR2 protocols. This binding describes a given instance
+of the EMIF IP and memory parts attached to it.
+
+Required properties:
+- compatible : Should be of the form "ti,emif-<ip-rev>" where <ip-rev>
+ is the IP revision of the specific EMIF instance.
+
+- phy-type : <u32> indicating the DDR phy type. Following are the
+ allowed values
+ <1> : Attila PHY
+ <2> : Intelli PHY
+
+- device-handle : phandle to a "lpddr2" node representing the memory part
+ attached to this EMIF instance.
+
+Optional properties:
+- cs1-used : Have this property if CS1 of this EMIF
+ instance has a memory part attached to it. If there is a memory
+ part attached to CS1, it should be the same type as the one on CS0,
+ so there is no need to give the details of this memory part.
+
+- cal-resistor-per-cs : Have this property if the board has one
+ calibration resistor per chip-select.
+
+- hw-caps-read-idle-ctrl: Have this property if the controller
+ supports read idle window programming
+
+- hw-caps-ll-interface : Have this property if the controller
+ has a low latency interface and corresponding interrupt events
+
+- hw-caps-temp-alert : Have this property if the controller
+ has capability for generating SDRAM temperature alerts
+
+Example:
+
+emif1: emif@0x4c000000 {
+ compatible = "ti,emif-4d";
+ ti,hwmods = "emif2";
+ phy-type = <1>;
+ device-handle = <&elpida_ECB240ABACN>;
+ cs1-used;
+ hw-caps-read-idle-ctrl;
+ hw-caps-ll-interface;
+ hw-caps-temp-alert;
+};
--
1.7.1
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
