- The reset in the driver at init is not needed anymore as the
hwmod framework takes care of reseting it.
- Reset is removed from omap_i2c_init, which was called
not only during probe, but also after time out and error handling.
device_reset were added in those places to effect the reset.
- Earlier the hwmod SYSC settings were over-written in the driver.
Removing the same and letting the hwmod take care of the settings.
- Clean up the SYSS_RESETDONE_MASK macro as it is no longer needed.
- Clean up the SYSCONFIG SYSC bit defination macros.
- Fix the typos in wakeup.
Signed-off-by: Shubhrajyoti D <shubhrajyoti@xxxxxx>
---
drivers/i2c/busses/i2c-omap.c | 83 +++++++++++------------------------------
1 files changed, 22 insertions(+), 61 deletions(-)
diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
index 4e3256f..d8f4470 100644
--- a/drivers/i2c/busses/i2c-omap.c
+++ b/drivers/i2c/busses/i2c-omap.c
@@ -155,19 +155,6 @@ enum {
#define OMAP_I2C_SYSTEST_SDA_O (1 << 0) /* SDA line drive out */
#endif
-/* OCP_SYSSTATUS bit definitions */
-#define SYSS_RESETDONE_MASK (1 << 0)
-
-/* OCP_SYSCONFIG bit definitions */
-#define SYSC_CLOCKACTIVITY_MASK (0x3 << 8)
-#define SYSC_SIDLEMODE_MASK (0x3 << 3)
-#define SYSC_ENAWAKEUP_MASK (1 << 2)
-#define SYSC_SOFTRESET_MASK (1 << 1)
-#define SYSC_AUTOIDLE_MASK (1 << 0)
-
-#define SYSC_IDLEMODE_SMART 0x2
-#define SYSC_CLOCKACTIVITY_FCLK 0x2
-
/* Errata definitions */
#define I2C_OMAP_ERRATA_I207 (1 << 0)
#define I2C_OMAP3_1P153 (1 << 1)
@@ -182,6 +169,7 @@ struct omap_i2c_dev {
u32 latency; /* maximum mpu wkup latency */
void (*set_mpu_wkup_lat)(struct device *dev,
long latency);
+ int (*device_reset)(struct device *dev);
u32 speed; /* Speed of bus in Khz */
u16 cmd_err;
u8 *buf;
@@ -317,60 +305,22 @@ static int omap_i2c_init(struct omap_i2c_dev *dev)
u16 psc = 0, scll = 0, sclh = 0, buf = 0;
u16 fsscll = 0, fssclh = 0, hsscll = 0, hssclh = 0;
unsigned long fclk_rate = 12000000;
- unsigned long timeout;
unsigned long internal_clk = 0;
struct clk *fclk;
struct omap_i2c_bus_platform_data *pdata;
pdata = dev->dev->platform_data;
- if (dev->rev >= OMAP_I2C_OMAP1_REV_2) {
- /* Disable I2C controller before soft reset */
- omap_i2c_write_reg(dev, OMAP_I2C_CON_REG,
- omap_i2c_read_reg(dev, OMAP_I2C_CON_REG) &
- ~(OMAP_I2C_CON_EN));
-
- omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, SYSC_SOFTRESET_MASK);
- /* For some reason we need to set the EN bit before the
- * reset done bit gets set. */
- timeout = jiffies + OMAP_I2C_TIMEOUT;
- omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, OMAP_I2C_CON_EN);
- while (!(omap_i2c_read_reg(dev, OMAP_I2C_SYSS_REG) &
- SYSS_RESETDONE_MASK)) {
- if (time_after(jiffies, timeout)) {
- dev_warn(dev->dev, "timeout waiting "
- "for controller reset\n");
- return -ETIMEDOUT;
- }
- msleep(1);
- }
-
- /* SYSC register is cleared by the reset; rewrite it */
- if (dev->rev == OMAP_I2C_REV_ON_2430) {
-
- omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG,
- SYSC_AUTOIDLE_MASK);
-
- } else if (dev->rev >= OMAP_I2C_REV_ON_3430) {
- dev->syscstate = SYSC_AUTOIDLE_MASK;
- dev->syscstate |= SYSC_ENAWAKEUP_MASK;
- dev->syscstate |= (SYSC_IDLEMODE_SMART <<
- __ffs(SYSC_SIDLEMODE_MASK));
- dev->syscstate |= (SYSC_CLOCKACTIVITY_FCLK <<
- __ffs(SYSC_CLOCKACTIVITY_MASK));
-
- omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG,
- dev->syscstate);
- /*
- * Enabling all wakup sources to stop I2C freezing on
- * WFI instruction.
- * REVISIT: Some wkup sources might not be needed.
- */
- dev->westate = OMAP_I2C_WE_ALL;
- if (dev->rev < OMAP_I2C_REV_ON_3530_4430)
- omap_i2c_write_reg(dev, OMAP_I2C_WE_REG,
- dev->westate);
- }
+ if (dev->rev >= OMAP_I2C_REV_ON_3430) {
+ /*
+ * Enabling all wakeup sources to stop I2C freezing on
+ * WFI instruction.
+ * REVISIT: Some wakeup sources might not be needed.
+ */
+ dev->westate = OMAP_I2C_WE_ALL;
+ if (dev->rev < OMAP_I2C_REV_ON_3530_4430)
+ omap_i2c_write_reg(dev, OMAP_I2C_WE_REG,
+ dev->westate);
}
omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, 0);
@@ -595,6 +545,11 @@ static int omap_i2c_xfer_msg(struct i2c_adapter *adap,
return r;
if (r == 0) {
dev_err(dev->dev, "controller timed out\n");
+ if (dev->device_reset != NULL) {
+ r = dev->device_reset(dev->dev);
+ if (r < 0)
+ dev_err(dev->dev, "reset failed\n");
+ }
omap_i2c_init(dev);
return -ETIMEDOUT;
}
@@ -605,6 +560,11 @@ static int omap_i2c_xfer_msg(struct i2c_adapter *adap,
/* We have an error */
if (dev->cmd_err & (OMAP_I2C_STAT_AL | OMAP_I2C_STAT_ROVR |
OMAP_I2C_STAT_XUDF)) {
+ if (dev->device_reset != NULL) {
+ r = dev->device_reset(dev->dev);
+ if (r < 0)
+ dev_err(dev->dev, "reset failed\n");
+ }
omap_i2c_init(dev);
return -EIO;
}
@@ -1005,6 +965,7 @@ omap_i2c_probe(struct platform_device *pdev)
if (pdata != NULL) {
speed = pdata->clkrate;
dev->set_mpu_wkup_lat = pdata->set_mpu_wkup_lat;
+ dev->device_reset = pdata->device_reset;
} else {
speed = 100; /* Default speed */
dev->set_mpu_wkup_lat = NULL;
--
1.7.1
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
