Nishanth Menon <nm@xxxxxx> writes: > if volt_reg and cmd_reg are the same from PMIC configuration, > we can use the cmd reg by using racen - -ECONFUSED If volt_reg and cmd_reg are the same then I understood RACEN to be a don't care. Zero means use volt_reg, 1 means use cmd_reg, but if volt_reg == cmd_reg, then either way is the same result. The way I understood (and coded) this is that the only time you need RACEN set is precicesly the case when a cmd_reg is provided (and thus is different from volt_reg. What am I missing? Or, stated differently, I guess I don't understand the use case for RAC != RACEN Kevin > this is valid for > voltage commands, however, in most cases, we'd like to retain > voltage reg configuration as well for vfsm commands going thru > from h/w. > > Signed-off-by: Nishanth Menon <nm@xxxxxx> > --- > arch/arm/mach-omap2/vc.c | 6 +++++- > 1 files changed, 5 insertions(+), 1 deletions(-) > > diff --git a/arch/arm/mach-omap2/vc.c b/arch/arm/mach-omap2/vc.c > index 0c0e416..6017c70 100644 > --- a/arch/arm/mach-omap2/vc.c > +++ b/arch/arm/mach-omap2/vc.c > @@ -337,9 +337,13 @@ void __init omap_vc_init_channel(struct voltagedomain *voltdm) > voltdm->rmw(vc->smps_cmdra_mask, > vc->cmd_reg_addr << __ffs(vc->smps_cmdra_mask), > vc->common->smps_cmdra_reg); > - vc->cfg_channel |= vc_cfg_bits->rac | vc_cfg_bits->racen; > + vc->cfg_channel |= vc_cfg_bits->rac; > } > > + /* If voltage and cmd regs are same, we can use cmdra register */ > + if (vc->volt_reg_addr == vc->cmd_reg_addr) > + vc->cfg_channel |= vc_cfg_bits->racen; > + > /* Set up the on, inactive, retention and off voltage */ > on_vsel = voltdm->pmic->uv_to_vsel(voltdm->pmic->on_volt); > onlp_vsel = voltdm->pmic->uv_to_vsel(voltdm->pmic->onlp_volt); -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
