LANEx_ULPS_SIG2 bits are left on after entering ULPS. This doesn't cause any problems currently, as DSI HW is reset when it is enabled. However, if the reset is not done, operation fails if the bits are still set. So reset the bits after entering ULPS to ensure operation even without HW reset. Signed-off-by: Tomi Valkeinen <tomi.valkeinen@xxxxxx> --- drivers/video/omap2/dss/dsi.c | 4 ++++ 1 files changed, 4 insertions(+), 0 deletions(-) diff --git a/drivers/video/omap2/dss/dsi.c b/drivers/video/omap2/dss/dsi.c index 69c2d4f..4496d09 100644 --- a/drivers/video/omap2/dss/dsi.c +++ b/drivers/video/omap2/dss/dsi.c @@ -3395,6 +3395,10 @@ static int dsi_enter_ulps(struct platform_device *dsidev) dsi_unregister_isr_cio(dsidev, dsi_completion_handler, &completion, DSI_CIO_IRQ_ULPSACTIVENOT_ALL0); + /* Reset LANEx_ULPS_SIG2 */ + REG_FLD_MOD(dsidev, DSI_COMPLEXIO_CFG2, (0 << 0) | (0 << 1) | (0 << 2), + 7, 5); + dsi_cio_power(dsidev, DSI_COMPLEXIO_POWER_ULPS); dsi_if_enable(dsidev, false); -- 1.7.4.1 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
