* Igor Grinberg <grinberg@xxxxxxxxxxxxxx> [110508 00:17]:
> cm-t3730 is basically the same board as cm-t35, but has DM3730 SoC
> assembled and therefore some changes are required.
> +static void cm_t35_mux_init(void)
> +{
> + int mux_mode = OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT;
> +
> + omap3_mux_init(cm_t35_common_board_mux, OMAP_PACKAGE_CUS);
> +
> + if (cpu_is_omap34xx()) {
> + omap_mux_init_signal("gpio_70", mux_mode);
> + omap_mux_init_signal("gpio_71", mux_mode);
> + omap_mux_init_signal("gpio_72", mux_mode);
> + omap_mux_init_signal("gpio_73", mux_mode);
> + omap_mux_init_signal("gpio_74", mux_mode);
> + omap_mux_init_signal("gpio_75", mux_mode);
> + } else if (cpu_is_omap3630()) {
> + mux_mode = OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT;
> + omap_mux_init_signal("sys_boot0", mux_mode);
> + omap_mux_init_signal("sys_boot1", mux_mode);
> + omap_mux_init_signal("sys_boot3", mux_mode);
> + omap_mux_init_signal("sys_boot4", mux_mode);
> + omap_mux_init_signal("sys_boot5", mux_mode);
> + omap_mux_init_signal("sys_boot6", mux_mode);
> + }
> +
> + omap_mux_init_signal("dss_data18", mux_mode);
> + omap_mux_init_signal("dss_data19", mux_mode);
> + omap_mux_init_signal("dss_data20", mux_mode);
> + omap_mux_init_signal("dss_data21", mux_mode);
> + omap_mux_init_signal("dss_data22", mux_mode);
> + omap_mux_init_signal("dss_data23", mux_mode);
> +}
> +#else
> +static inline void cm_t35_mux_init(void) {}
> #endif
Should this cpu_is_omap if else done once and then set
some data based on it? That would be better if you need to
use it for detection for other things later on as it will
avoid multiple cpu_is/machine_is if else lines of code.
Regards,
Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
