On 5/27/2011 8:30 PM, Cousson, Benoit wrote:
On 5/27/2011 4:51 PM, Shilimkar, Santosh wrote:
On 5/27/2011 8:13 PM, Cousson, Benoit wrote:
On 5/27/2011 2:46 PM, Valkeinen, Tomi wrote:
On Fri, 2011-05-27 at 14:38 +0200, Cousson, Benoit wrote:
Hi Tomi,
On 5/27/2011 9:38 AM, Valkeinen, Tomi wrote:
Add omap_device_reset() function which can be used to reset the
hwmods
associated with the given platform device.
We've never exposed it because we are trying to avoid that any driver
play with asynchronous HW reset. That can lead to undefined HW
behavior :-(
Do you have some strong need for that?
DSS driver has been designed so that it resets the HW before it begins
programming it. That way we get the HW into known state. Otherwise we
need to be extra careful to program all possible registers to a sane
value. Not impossible, of course, but requires extra work.
I noticed the problem with DSI driver, it didn't work anymore if I
didn't reset it.
Why does it lead to undefined HW behaviour? Isn't it much better to
reset the HW before starting to use it to be 100% sure it's in known
and
valid state?
In theory, but since your are resetting only the DSS IP, it can leads to
side effect at SoC level. Especially wrt to clock management.
Especially in error situations it may be difficult (even impossible) to
recover without reset. DISPC has been known to froze in some sync lost
situations, and, if I recall right, if DSI transfer is aborted the only
way to recover is to reset the DSI block (on OMAP3).
In case of recovery error it makes sense. What we did with hardreset is
to re-assert the reset upon disable of the module and then the next
enable will de-assert it. Softreset does not do that today.
I didn't notice this patch but Paul reported an issue on beagle
which was making L3 error handling driver hang.
Later on after debugging we noticed, that DSS initiator
was throwing timeout error.
As a temporary fix, we removed the timeout error from
the handler since root-cause was not known. [1]
I am not sure but may be a proper DSS reset might fix
that issue as well.
Yeah, but this is the issue... people will start abusing that to fix any
kind of problems instead of finding the root cause.
May be you are right. But shouldn't we do a proper reset of the IP.
On this same topic, I have a patch for timer IP too. As per
TRM, soft reset is not enough to properly reset the timer IP
and expecting the additional register to be used for
reseting the timer IP.
That should be use only to fix real HW issue that cannot be solve
properly by SW.
I agree but TRM doesn't say the softreset is enough to ensure
the certain IP's are properly reseted.
Regards
Santosh
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
