The current DSI driver design requires the DSI panel driver to specify the DSI Virtual Channel and the Panel Virtual Channel ID for the transfer of commands and frame data. Out of these, only the second parameter is a property of the Panel. The DSI Virtual Channel in use by the panel driver ideally shouldn't be provided by the panel driver. The current design leads to the following issues: -Multiple panels connected to the same DSI interface would be unaware of the VC's in use. -Hard coded Virtual Channel numbers in panel drivers which is not generic. -No clean way of configuring DSI for panels which need atleast 2 DSI Virtual Channels. -No clean way of configuring DSI for the special case where a panel may have 2 or VC ID's corresponding to it. The panel driver should, instead, request for, and release DSI Virtual Channels through calls to the DSI driver. The DSI driver should return VC numbers which the panel can use. The panel driver then uses this VC to either send pixel data, send commands and receive data from the panel. The DSI driver then automatically configures the Virtual Channel source to either Video Port or L4 Slave Port. This patch set tries to achieve the above design, and make Panel Taal driver use this approach. Note: Patches can be tested on: http://dev.omapzoom.org/?p=axelcx/kernel-display.git;a=shortlog;h=refs/heads/lo-dss2-Feb25 Archit Taneja (3): OMAP: DSS2: Functions to request/release DSI VCs OMAP: DSS2: Use request / release calls in Taal for DSI Virtual Channels. OMAP: DSS2: Taal: Use 2 DSI Virtual Channels for Taal arch/arm/plat-omap/include/plat/display.h | 3 + drivers/video/omap2/displays/panel-taal.c | 121 +++++++++++++++++------------ drivers/video/omap2/dss/dsi.c | 58 ++++++++++++-- 3 files changed, 124 insertions(+), 58 deletions(-) -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
