Hi, On Tue, 2010-11-23 at 19:00 -0600, ext Omar Ramirez Luna wrote: > From: Yanick Saugy <yanick.saugy@xxxxxxxxxx> > > The PIN which controls LCD's reset signal (VGA_nRESET/h_GPIO_96) was not > configured as a GPIO. We had to modify the OMAP MUX, and select this PIN > (CAM_XCLKA) as an output GPIO (OMAP_MUX_MODE4). (kernel 2.6.35) > > Be aware of changing this PIN will probably disable the camera, because > it was previously configured as a camera clock. > > Signed-off-by: Yanick Saugy <yanick.saugy@xxxxxxxxxx> > Acked-by: Tony Lindgren <tony@xxxxxxxxxxx> > Signed-off-by: Omar Ramirez Luna <omar.ramirez@xxxxxx> > --- > > I'm not sure if this patch was forgotten, hence resending. Without > it, a blanks screen is seen on zoom2 board. Yes, I seem to have missed this. But I'm a bit confused. You say that this will disable camera. Is there a camera connected to the board, and it won't work after this? Tomi -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html