2010/9/15 Felipe Balbi <balbi@xxxxxx>:
> Hi,
>
> On Wed, Sep 15, 2010 at 05:53:10AM -0500, Ming Lei wrote:
>>
>> 1), why is the check for "is_dma" needed here?
>>
>> if (is_dma || request->actual == request->length) {
>> ....
>> }
>
> if you programmed dma to request->length (and assuming it worked just
> fine) mode1 will only interrupt you when the entire request has been
> sent.
If so, once the dma interrupt comes, will request->actual be same
with request->length in musb_g_tx? And if it is true, could we remove the
check for 'is_dma'?
>
>> 2), why is a zlp needed in the case below?
>>
>> #ifdef CONFIG_USB_INVENTRA_DMA
>> || (is_dma && (!dma->desired_mode ||
>> (request->actual & (musb_ep->packet_sz - 1))))
>> #endif
>
> in that case, it's not a zlp, it's short packet. Inventra will *NOT*
> transfer short packets, you need to set txpktrdy by hand to get it
> transfered.
I see now.
>
>> IMO, it is not difficult to give a good fix for the ZLP problem
>> if the two questions are clear.
>
> true, but some re-work needs to be done.
Thanks for your reply.
--
Lei Ming
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
