Hi Linus,
Please pull OMAP Display Subsystem patches from below. Mostly fixes and
improvements to existing features.
Tomi
The following changes since commit 9fe6206f400646a2322096b56c59891d530e8d51:
Linus Torvalds (1):
Linux 2.6.35
are available in the git repository at:
git://gitorious.org/linux-omap-dss2/linux.git for-linus
Afzal Mohammed (1):
OMAP: DSS2: OMAPFB: Fix probe error path
Archit Taneja (3):
OMAP: DSS2: Remove extra return statement
OMAP: DSS2: Fix error path in omap_dsi_update()
OMAP: DSS2: Replace strncmp() with sysfs_streq() in overlay_manager_store()
Grazvydas Ignotas (1):
OMAP: DSS2: OMAPFB: add support for FBIO_WAITFORVSYNC
Igor Grinberg (1):
OMAP: DSS2: TDO35S: fix video signaling
Jani Nikula (21):
OMAP: DSS2: Taal: Add panel hardware reset
OMAP: DSS2: Taal: Add locks to protect taal data access
OMAP: DSS2: Taal: Remove platform enable/disable
OMAP: DSS2: Taal: Fix request_irq() error handling
OMAP: DSS2: Taal: Remove ESD work cancel from driver probe error handling
OMAP: DSS2: Taal: Improve taal_power_on() error handling
OMAP: DSS2: Taal: Ensure panel is enabled in enable_te() and run_test()
OMAP: DSS2: Taal: Change DSI bus locking to avoid deadlock in ESD work
OMAP: DSS2: Taal: Check taal_power_on() return value in taal_resume()
OMAP: DSS2: Taal: Change ESD work management
OMAP: DSS2: Taal: Change probe error handling labels
OMAP: DSS2: Taal: Add proper external TE support
OMAP: DSS2: Add Nokia DSI command mode panel configuration struct
OMAP: DSS2: Taal: Configure ESD check in DSI panel data
OMAP: DSS2: Taal: Add panel specific configuration structure
OMAP: DSS2: Taal: Print panel name in addition to revision
OMAP: DSS2: Taal: CABC workaround is Taal specific
OMAP: DSS2: OMAPFB: Check fb2display() return value
OMAP: DSS2: OMAPFB: Remove redundant rotate range check
OMAP: DSS2: OMAPFB: Remove redundant color register range check
OMAP: DSS2: OMAPFB: Fix sysfs mirror input check
Maurus Cuelenaere (1):
OMAP: DSS2: OMAPFB: Fix invalid bpp for PAL and NTSC modes
Tobias Klauser (1):
OMAP: DSS2: storage class should be before const qualifier
Tomi Valkeinen (20):
OMAP: DSS2: DSI: Increase HS TX timeout
OMAP: DSS2: Fix update area calculations with multiple scaled overlays
OMAP: DSS2: DSI: print errors in dsi_vc_flush_receive_data()
OMAP: DSS2: DSI: use a private workqueue
OMAP: DSS2: DSI: change dsi_vc_dcs_read_2 parameters
OMAP: DSS2: DSI: handle error in synchronous write
OMAP: DSS2: DSI: change DSI timeout functions
OMAP: DSS2: Taal: add locks to taal_bl_update_status
OMAP: DSS2: Taal: Use Nokia DSI panel data
OMAP: DSS2: Taal: Add regulator configuration support
OMAP: DSS2: DSI: Wait for DSI PLL clocks to be active before selecting them
OMAP: DSS2: DSI: change dsi_vc_config_l4/vp()
OMAP: DSS2: DSI: use BTA to end the frame transfer
OMAP: DSS2: change manual update scaling setup
OMAP: DSS2: DSI: Remove BTA after set_max_rx_packet_size
OMAP: DSS2: DSI: Add error IRQ mask for DSI complexIO
OMAP: DSS2: DSI: increase FIFO low threshold
OMAP: DSS2: DSI: detect unsupported update requests
OMAP: DSS2: Taal: Optimize enable_te, rotate, mirror when value unchanged
OMAP: DSS2: adjust YUV overlay width to be even
Vaibhav Hiremath (1):
OMAP3EVM: Replace vdvi regulator supply with vdds_dsi
Ville Syrjälä (14):
OMAP: DSS2: Check if display supports update mode changes
OMAP: DSS2: Make wait_for_go() succeed for disabled displays
OMAP: DSS2: clear spurious SYNC_LOST_DIGIT interrupts
OMAP: DSS2: OMAPFB: Refactor overlay address calculations
OMAP: DSS2: OMAPFB: Check var even if there isn't memory
OMAP: DSS2: OMAPFB: Skip unnecessary set_overlay_info()
OMAP: DSS2: OMAPFB: Add support for switching memory regions
OMAP: DSS2: OMAPFB: Add locking for memory regions
OMAP: DSS2: OMAPFB: Convert the memory region locking to rwsem
OMAP: DSS2: OMAPFB: Make lockdep happy
OMAP: DSS2: OMAPFB: Add some locking debug checks
OMAP: DSS2: DSI: Disable PCKFREE on error
OMAP: DSS2: DSI: Print an error message if DSI clock calc fails
OMAP: DSS2: DSI: Disable interface when disabling the display
arch/arm/mach-omap2/board-omap3evm.c | 7 +-
arch/arm/plat-omap/include/plat/display.h | 9 +-
arch/arm/plat-omap/include/plat/nokia-dsi-panel.h | 31 ++
drivers/video/omap2/displays/panel-taal.c | 567 +++++++++++++++----
.../video/omap2/displays/panel-toppoly-tdo35s.c | 8 +-
drivers/video/omap2/dss/dispc.c | 16 +-
drivers/video/omap2/dss/display.c | 4 +-
drivers/video/omap2/dss/dsi.c | 463 ++++++++---------
drivers/video/omap2/dss/dss.c | 6 +
drivers/video/omap2/dss/dss.h | 11 +-
drivers/video/omap2/dss/manager.c | 236 +++++----
drivers/video/omap2/dss/overlay.c | 2 +-
drivers/video/omap2/dss/rfbi.c | 2 +-
drivers/video/omap2/omapfb/omapfb-ioctl.c | 188 ++++++-
drivers/video/omap2/omapfb/omapfb-main.c | 229 ++++++---
drivers/video/omap2/omapfb/omapfb-sysfs.c | 70 ++-
drivers/video/omap2/omapfb/omapfb.h | 29 +-
include/linux/omapfb.h | 5 +-
18 files changed, 1281 insertions(+), 602 deletions(-)
create mode 100644 arch/arm/plat-omap/include/plat/nokia-dsi-panel.h
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
