Nishanth Menon <nm@xxxxxx> writes: > Kevin Hilman had written, on 08/04/2010 05:50 PM, the following: > [...] > >> I've only tested the new PM branch on a couple boards to avoid any >> further delay getting this version out, update, so hopefully others will >> help test. >> >> I've tested RET on idle & suspend, OFF in idle & suspend on: >> >> 3430/omap3evm: works >> >> 3630/Zoom3: works >> - Known problem: console hangs on UART wakeup when wakeups are enabled using >> echo enabled > /sys/devices/platform/serial8250.0/tty/ttyS0/power/wakeup >> but I haven't debugged this further. > > Just sharing results from SDP testing omap3_pm_defconfig + earlyprintk: > SDP3430 (with denx.com u-boot, nor boot): does not boot to shell > full Bootlog: http://pastebin.mozilla.org/761964 Does the same setup boot fine on l-o for-next, or l-o master? > SDP3630 (with TI u-boot, xloader, mmc boot): ret works, uart wakeup > fails for off mode (I am guessing this is similar to Kevin's results) > full Bootlog: http://pastebin.mozilla.org/761966 > OMAP4 Blaze (with TI u-boot, xloader, mmc boot): does not boot, hell > lot of crashes - note, need to explicitly enable MACH_OMAP4430_SDP in > .config > full Bootlog: http://pastebin.mozilla.org/761968 yeah, I don't expect PM branch to work on OMAP4 until we get the OMAP4 hwmod core upstream. Kevin -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
