Sapiens, Rene <rene.sapiens <at> ti.com> writes: > > You can do a telnet to the device... you should be able to work with it but your serial session will show the garbage. > > Regards, > Rene > Hello, I am in essentially the same position, but currently working off of the pm-head branch. I am just using an initramfs, and have tried a few variations. With no_console_suspend set, I can trigger a wakeup using the wakeup_timer_seconds. The power usage goes back to the pre-suspend level, and I see text indicating a successful wakeup, but the console never comes back. Without no_console_suspend set, I can trigger the wakeup again with wakeup_timer_seconds, a console prompt comes back, but is unresponsive. I saw Rene's response about using Telnet, but this implies that there is an ethernet interface available. I have a custom board that only has a serial interface for external visibility, so at this point I lose insight into what is happening on the board. I have two questions, if people would be so willing to oblige: 1) Does anyone know why the console doesn't come back after wakeup? Is this something that may work in the future? 2) Does the console freezing mean that the other COM ports also don't work? Would communication on other interfaces continue to work? For example, a GPS plugged into one of the other COM ports? Thanks, Tyler -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html