The Devkit8000 uses the cost reduced variant tps65930 of the twl4030.
The TPS65930 only has vdd1, vdd2, vpll1, vio, vmmc1, vdac and vaux2.
vaux2 is not used on Devkit8000.
Signed-off-by: Thomas Weber <weber@xxxxxxxxxxxxx>
---
arch/arm/mach-omap2/board-devkit8000.c | 22 ----------------------
1 files changed, 0 insertions(+), 22 deletions(-)
diff --git a/arch/arm/mach-omap2/board-devkit8000.c b/arch/arm/mach-omap2/board-devkit8000.c
index 8cc8c3b..59877b1 100644
--- a/arch/arm/mach-omap2/board-devkit8000.c
+++ b/arch/arm/mach-omap2/board-devkit8000.c
@@ -168,15 +168,10 @@ static void devkit8000_panel_disable_tv(struct omap_dss_device *dssdev)
{
}
-
static struct regulator_consumer_supply devkit8000_vmmc1_supply = {
.supply = "vmmc",
};
-static struct regulator_consumer_supply devkit8000_vsim_supply = {
- .supply = "vmmc_aux",
-};
-
/* ads7846 on SPI */
static struct regulator_consumer_supply devkit8000_vio_supplies[] = {
REGULATOR_SUPPLY("vcc", "spi2.0")
@@ -281,7 +276,6 @@ static int devkit8000_twl_gpio_setup(struct device *dev,
/* link regulators to MMC adapters */
devkit8000_vmmc1_supply.dev = mmc[0].dev;
- devkit8000_vsim_supply.dev = mmc[0].dev;
/* TWL4030_GPIO_MAX + 1 == ledB, PMU_STAT (out, active low LED) */
gpio_leds[2].gpio = gpio + TWL4030_GPIO_MAX + 1;
@@ -334,21 +328,6 @@ static struct regulator_init_data devkit8000_vmmc1 = {
.consumer_supplies = &devkit8000_vmmc1_supply,
};
-/* VSIM for MMC1 pins DAT4..DAT7 (2 mA, plus card == max 50 mA) */
-static struct regulator_init_data devkit8000_vsim = {
- .constraints = {
- .min_uV = 1800000,
- .max_uV = 3000000,
- .valid_modes_mask = REGULATOR_MODE_NORMAL
- | REGULATOR_MODE_STANDBY,
- .valid_ops_mask = REGULATOR_CHANGE_VOLTAGE
- | REGULATOR_CHANGE_MODE
- | REGULATOR_CHANGE_STATUS,
- },
- .num_consumer_supplies = 1,
- .consumer_supplies = &devkit8000_vsim_supply,
-};
-
/* VDAC for DSS driving S-Video (8 mA unloaded, max 65 mA) */
static struct regulator_init_data devkit8000_vdac = {
.constraints = {
@@ -414,7 +393,6 @@ static struct twl4030_platform_data devkit8000_twldata = {
.gpio = &devkit8000_gpio_data,
.codec = &devkit8000_codec_data,
.vmmc1 = &devkit8000_vmmc1,
- .vsim = &devkit8000_vsim,
.vdac = &devkit8000_vdac,
.vpll1 = &devkit8000_vpll1,
.vio = &devkit8000_vio,
--
1.7.1
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
