Hi,
Phaneendra Kumar Alapati wrote:
> This patch adds SDIO IRQ support for OMAP35xx. Tested on OMAP3530EVM
> with Marvell 88W8686 card and below are the observed throughput results
> (ttcp utility): 13Mbps (Downlink), 10.5 Mbps(Uplink)
>
> Signed-off-by: Phaneendra Kumar <phani@xxxxxxxxxxx>
> ---
> drivers/mmc/host/omap_hsmmc.c | 55 ++++++++++++++++++++++++++++++++++++----
> 1 files changed, 49 insertions(+), 6 deletions(-)
I've tried the patch on CM-T35 that has Marvell 88W8686 on-board and
surprisingly I get a lot of command timeouts from the libertas driver :(
---
libertas: requeueing command 0x0006 due to timeout (#1)
libertas: Received result 0 to command 6 after 1 retries
libertas: command 0x0006 timed out
---
I hope I'll find time to debug it in the next few days and provide more valuable
information...
> diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
> index 4b23225..fa94580 100644
> --- a/drivers/mmc/host/omap_hsmmc.c
> +++ b/drivers/mmc/host/omap_hsmmc.c
> @@ -100,6 +100,10 @@
> #define SRD (1 << 26)
> #define SOFTRESET (1 << 1)
> #define RESETDONE (1 << 0)
> +#define CIRQ (1 << 8)
> +#define CIRQ_ENABLE (1 << 8)
> +#define CTPL (1 << 11)
> +#define CLKEXTFREE (1 << 16)
>
> /*
> * FIXME: Most likely all the data using these _DEVID defines should come
> @@ -171,6 +175,7 @@ struct omap_hsmmc_host {
> int vdd;
> int protect_card;
> int reqs_blocked;
> + int sdio_int;
>
> struct omap_mmc_platform_data *pdata;
> };
> @@ -436,6 +441,13 @@ omap_hsmmc_start_command(struct omap_hsmmc_host *host, struct mmc_command *cmd,
> else
> OMAP_HSMMC_WRITE(host->base, IE, INT_EN_MASK);
>
> + if (host->sdio_int) {
> + OMAP_HSMMC_WRITE(host->base, ISE,
> + (OMAP_HSMMC_READ(host->base, ISE) | CIRQ_ENABLE));
> + OMAP_HSMMC_WRITE(host->base, IE,
> + (OMAP_HSMMC_READ(host->base, IE) | CIRQ_ENABLE));
> + }
> +
> host->response_busy = 0;
> if (cmd->flags & MMC_RSP_PRESENT) {
> if (cmd->flags & MMC_RSP_136)
> @@ -640,6 +652,17 @@ static irqreturn_t omap_hsmmc_irq(int irq, void *dev_id)
>
> spin_lock(&host->irq_lock);
>
> + data = host->data;
> + status = OMAP_HSMMC_READ(host->base, STAT);
> + dev_dbg(mmc_dev(host->mmc), "IRQ Status is %x\n", status);
> +
> + if (host->mmc->caps & MMC_CAP_SDIO_IRQ) {
> + if (status & CIRQ) {
> + dev_dbg(mmc_dev(host->mmc), "SDIO Card Interrupt\n");
> + mmc_signal_sdio_irq(host->mmc);
> + }
> + }
> +
> if (host->mrq == NULL) {
> OMAP_HSMMC_WRITE(host->base, STAT,
> OMAP_HSMMC_READ(host->base, STAT));
> @@ -649,10 +672,6 @@ static irqreturn_t omap_hsmmc_irq(int irq, void *dev_id)
> return IRQ_HANDLED;
> }
>
> - data = host->data;
> - status = OMAP_HSMMC_READ(host->base, STAT);
> - dev_dbg(mmc_dev(host->mmc), "IRQ Status is %x\n", status);
> -
> if (status & ERR) {
> #ifdef CONFIG_MMC_DEBUG
> omap_hsmmc_report_irq(host, status);
> @@ -1254,6 +1273,25 @@ static int omap_hsmmc_get_ro(struct mmc_host *mmc)
> return mmc_slot(host).get_ro(host->dev, 0);
> }
>
> +static void omap_hsmmc_enable_sdio_irq(struct mmc_host *mmc, int enable)
> +{
> + struct omap_hsmmc_host *host = mmc_priv(mmc);
> +
> + host->sdio_int = enable;
> + if (enable) {
> + OMAP_HSMMC_WRITE(host->base, ISE,
> + (OMAP_HSMMC_READ(host->base, ISE) | CIRQ_ENABLE));
> + OMAP_HSMMC_WRITE(host->base, IE,
> + (OMAP_HSMMC_READ(host->base, IE) | CIRQ_ENABLE));
> + } else {
> + OMAP_HSMMC_WRITE(host->base, IE,
> + (OMAP_HSMMC_READ(host->base, IE) & (~CIRQ_ENABLE)));
> + OMAP_HSMMC_WRITE(host->base, ISE,
> + (OMAP_HSMMC_READ(host->base, ISE) & (~CIRQ_ENABLE)));
> + }
> +
> +}
> +
> static void omap_hsmmc_conf_bus_power(struct omap_hsmmc_host *host)
> {
> u32 hctl, capa, value;
> @@ -1519,7 +1557,7 @@ static const struct mmc_host_ops omap_hsmmc_ops = {
> .set_ios = omap_hsmmc_set_ios,
> .get_cd = omap_hsmmc_get_cd,
> .get_ro = omap_hsmmc_get_ro,
> - /* NYET -- enable_sdio_irq */
> + .enable_sdio_irq = omap_hsmmc_enable_sdio_irq,
> };
>
> static const struct mmc_host_ops omap_hsmmc_ps_ops = {
> @@ -1529,7 +1567,7 @@ static const struct mmc_host_ops omap_hsmmc_ps_ops = {
> .set_ios = omap_hsmmc_set_ios,
> .get_cd = omap_hsmmc_get_cd,
> .get_ro = omap_hsmmc_get_ro,
> - /* NYET -- enable_sdio_irq */
> + .enable_sdio_irq = omap_hsmmc_enable_sdio_irq,
> };
>
> #ifdef CONFIG_DEBUG_FS
> @@ -1657,6 +1695,7 @@ static int __init omap_hsmmc_probe(struct platform_device *pdev)
> host->mapbase = res->start;
> host->base = ioremap(host->mapbase, SZ_4K);
> host->power_mode = -1;
> + host->sdio_int = 0;
>
> platform_set_drvdata(pdev, host);
> INIT_WORK(&host->mmc_carddetect_work, omap_hsmmc_detect);
> @@ -1744,6 +1783,10 @@ static int __init omap_hsmmc_probe(struct platform_device *pdev)
> if (mmc_slot(host).nonremovable)
> mmc->caps |= MMC_CAP_NONREMOVABLE;
>
> + mmc->caps |= MMC_CAP_SDIO_IRQ;
> + OMAP_HSMMC_WRITE(host->base, CON,
> + OMAP_HSMMC_READ(host->base, CON) | (CTPL | CLKEXTFREE));
> +
> omap_hsmmc_conf_bus_power(host);
>
> /* Select DMA lines */
--
Sincerely yours,
Mike.
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
