* Koen Kooi <k.kooi@xxxxxxxxxxxxxxxxxx> [091103 06:11]: > Any comments on this, I need this on beagleboard to make ehci work. Looks like a fix to me, will queue. Tony > regards, > > Koen > > Op 24 okt 2009, om 09:59 heeft Jarkko Nikula het volgende geschreven: > > >The host port power is enabled by driving the nEN_USB_PWR low as > >stated in > >the comment. This fix is originally from Steve Sakoman > ><steve@xxxxxxxxxxx>. > > > >Signed-off-by: Jarkko Nikula <jhnikula@xxxxxxxxx> > >Cc: Steve Sakoman <steve@xxxxxxxxxxx> > >--- > >arch/arm/mach-omap2/board-omap3beagle.c | 2 +- > >1 files changed, 1 insertions(+), 1 deletions(-) > > > >diff --git a/arch/arm/mach-omap2/board-omap3beagle.c > >b/arch/arm/mach-omap2/board-omap3beagle.c > >index 6cb99f6..7ad9846 100644 > >--- a/arch/arm/mach-omap2/board-omap3beagle.c > >+++ b/arch/arm/mach-omap2/board-omap3beagle.c > >@@ -162,7 +162,7 @@ static int beagle_twl_gpio_setup(struct device > >*dev, > > > > /* TWL4030_GPIO_MAX + 0 == ledA, EHCI nEN_USB_PWR (out, active > >low) */ > > gpio_request(gpio + TWL4030_GPIO_MAX, "nEN_USB_PWR"); > >- gpio_direction_output(gpio + TWL4030_GPIO_MAX, 1); > >+ gpio_direction_output(gpio + TWL4030_GPIO_MAX, 0); > > > > /* TWL4030_GPIO_MAX + 1 == ledB, PMU_STAT (out, active low LED) */ > > gpio_leds[2].gpio = gpio + TWL4030_GPIO_MAX + 1; > >-- > >1.6.3.3 > > > >-- > >To unsubscribe from this list: send the line "unsubscribe linux- > >omap" in > >the body of a message to majordomo@xxxxxxxxxxxxxxx > >More majordomo info at http://vger.kernel.org/majordomo-info.html > > > > -- > To unsubscribe from this list: send the line "unsubscribe linux-omap" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html