From: Tero Kristo <tero.kristo@xxxxxxxxx>
Smartreflex for the corresponding powerdomain (MPU/CORE) must be disabled
before the domain enters retention, otherwise the device may hang. This is
caused by overlapping smartreflex / auto retention command on the voltage
channel resulting in incorrect voltage.
This fix has been confirmed from TI.
Signed-off-by: Tero Kristo <tero.kristo@xxxxxxxxx>
---
arch/arm/mach-omap2/pm34xx.c | 22 +++++++++++++++++-----
1 files changed, 17 insertions(+), 5 deletions(-)
diff --git a/arch/arm/mach-omap2/pm34xx.c b/arch/arm/mach-omap2/pm34xx.c
index 8353764..6782792 100644
--- a/arch/arm/mach-omap2/pm34xx.c
+++ b/arch/arm/mach-omap2/pm34xx.c
@@ -403,11 +403,17 @@ void omap_sram_idle(void)
if (pwrdm_read_pwrst(cam_pwrdm) == PWRDM_POWER_ON)
omap2_clkdm_deny_idle(mpu_pwrdm->pwrdm_clkdms[0]);
- /* CORE */
- if (core_next_state < PWRDM_POWER_ON) {
- /* Disable smartreflex before entering WFI */
+ /*
+ * Disable smartreflex before entering WFI.
+ * Only needed if we are going to enter retention or off.
+ */
+ if (mpu_next_state <= PWRDM_POWER_RET)
disable_smartreflex(SR1);
+ if (core_next_state <= PWRDM_POWER_RET)
disable_smartreflex(SR2);
+
+ /* CORE */
+ if (core_next_state < PWRDM_POWER_ON) {
omap_uart_prepare_idle(0);
omap_uart_prepare_idle(1);
if (core_next_state == PWRDM_POWER_OFF) {
@@ -480,10 +486,16 @@ void omap_sram_idle(void)
prm_clear_mod_reg_bits(OMAP3430_AUTO_RET,
OMAP3430_GR_MOD,
OMAP3_PRM_VOLTCTRL_OFFSET);
- /* Enable smartreflex after WFI */
+ }
+
+ /*
+ * Enable smartreflex after WFI. Only needed if we entered
+ * retention or off
+ */
+ if (mpu_next_state <= PWRDM_POWER_RET)
enable_smartreflex(SR1);
+ if (core_next_state <= PWRDM_POWER_RET)
enable_smartreflex(SR2);
- }
/* PER */
if (per_next_state < PWRDM_POWER_ON) {
--
1.5.4.3
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
