On Wednesday 09 September 2009 00:17:42 Kevin Hilman wrote:
> "Reddy, Teerth" <teerth@xxxxxx> writes:
> > This patch initializes the SDRC params for DVFS on Zoom2.
> >
> > Signed-off-by: Teerth Reddy <teerth@xxxxxx>
> > ---
> > arch/arm/mach-omap2/board-zoom2.c | 6 ++++--
> > 1 files changed, 4 insertions(+), 2 deletions(-)
> >
> > Index: linux-omap-pm/arch/arm/mach-omap2/board-zoom2.c
> > ===================================================================
> > --- linux-omap-pm.orig/arch/arm/mach-omap2/board-zoom2.c
> > +++ linux-omap-pm/arch/arm/mach-omap2/board-zoom2.c
> > @@ -23,6 +23,7 @@
> >
> > #include "mmc-twl4030.h"
> > #include "omap3-opp.h"
> > +#include "sdram-micron-mt46h32m32lf-6.h"
> >
> > static struct omap_uart_config zoom2_uart_config __initdata = {
> > .enabled_uarts = ((1 << 0) | (1 << 1) | (1 << 2)),
> > @@ -36,8 +37,9 @@ static void __init omap_zoom2_init_irq(v
> > {
> > omap_board_config = zoom2_config;
> > omap_board_config_size = ARRAY_SIZE(zoom2_config);
> > - omap2_init_common_hw(NULL, NULL, omap3_mpu_rate_table,
> > - omap3_dsp_rate_table, omap3_l3_rate_table);
> > + omap2_init_common_hw(mt46h32m32lf6_sdrc_params, NULL,
> > + omap3_mpu_rate_table, omap3_dsp_rate_table,
> > + omap3_l3_rate_table);
>
> Not having looked at the Zoom2 schematics, are you sure this is only
> using a single chip select? The other boards using the same part
> (beagle, overo) are interfacing to this part using both CSes.
>
> Have you tested DVFS on Zoom2 using the full 256Mb?
Good point!
DVFS works fine using the two chip selects:
omap2_init_common_hw(mt46h32m32lf6_sdrc_params,
mt46h32m32lf6_sdrc_params,
omap3_mpu_rate_table,
omap3_dsp_rate_table,
omap3_l3_rate_table);
One remark though: since the memory chips are popped on top of the OMAP chip
the schematics are not showing the chip selects connections. In any case
U-Boot is configuring the SDRC module to use the 2 chip selects, so I think
this change is needed.
We need confirmation. Anyone from TI knows?
Regards,
Jean
>
> Kevin
>
> > omap_init_irq();
> > omap_gpio_init();
> > }
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
