The Pandaboard needs a 32k clock in the TWL6030 to be enabled
to work. With some luck, it is enabled by some U-Boot fork.
Do not rely on it and properly specify the requirement.
Signed-off-by: Andreas Kemnade <andreas@xxxxxxxxxxxx>
---
arch/arm/boot/dts/ti/omap/omap4-panda-common.dtsi | 8 ++++++++
1 file changed, 8 insertions(+)
diff --git a/arch/arm/boot/dts/ti/omap/omap4-panda-common.dtsi b/arch/arm/boot/dts/ti/omap/omap4-panda-common.dtsi
index 97706d6296a6..c860b590142a 100644
--- a/arch/arm/boot/dts/ti/omap/omap4-panda-common.dtsi
+++ b/arch/arm/boot/dts/ti/omap/omap4-panda-common.dtsi
@@ -130,6 +130,12 @@ hsusb1_phy: hsusb1_phy {
clock-frequency = <19200000>;
};
+ wl12xx_pwrseq: wl12xx-pwrseq {
+ compatible = "mmc-pwrseq-simple";
+ clocks = <&twl 0>;
+ clock-names = "ext_clock";
+ };
+
/* regulator for wl12xx on sdio5 */
wl12xx_vmmc: wl12xx_vmmc {
pinctrl-names = "default";
@@ -408,6 +414,7 @@ twl: twl@48 {
reg = <0x48>;
/* IRQ# = 7 */
interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>; /* IRQ_SYS_1N cascaded to gic */
+ #clock-cells = <1>;
system-power-controller;
};
@@ -488,6 +495,7 @@ &mmc5 {
non-removable;
bus-width = <4>;
cap-power-off-card;
+ mmc-pwrseq = <&wl12xx_pwrseq>;
#address-cells = <1>;
#size-cells = <0>;
--
2.39.5
