Commit b9bf5612610aa7e3 ("ARM: dts: am335x-bone-common: Increase MDIO
reset deassert time") already increased the MDIO reset deassert delay
from 6.5 to 13 ms, but this may still cause Ethernet PHY probe failures:
SMSC LAN8710/LAN8720 4a101000.mdio:00: probe with driver SMSC LAN8710/LAN8720 failed with error -5
On BeagleBone Black Rev. C3, ETH_RESETn is controlled by an open-drain
AND gate. It is pulled high by a 10K resistor, and has a 4.7µF
capacitor to ground, giving an RC time constant of 47ms. As it takes
0.7RC to charge the capacitor above the threshold voltage of a CMOS
input (VDD/2), the delay should be at least 33ms. Considering the
typical tolerance of 20% on capacitors, 40ms would be safer. Add an
additional safety margin and settle for 50ms.
Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi b/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi
index a0fb431aec8411d8..212d7f867f8786af 100644
--- a/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi
+++ b/arch/arm/boot/dts/ti/omap/am335x-bone-common.dtsi
@@ -409,7 +409,7 @@ ethphy0: ethernet-phy@0 {
/* Support GPIO reset on revision C3 boards */
reset-gpios = <&gpio1 8 GPIO_ACTIVE_LOW>;
reset-assert-us = <300>;
- reset-deassert-us = <13000>;
+ reset-deassert-us = <50000>;
};
};
--
2.34.1
