* Trevor Woerner <twoerner@xxxxxxxxx> [230822 14:31]:
> Add the default MODE setting of a GPIO pin that was missing from the device
> tree (i.e. P2.20/gpio2_00). This is to ensure the GPIO pins match the
> pocketbeagle wiring expectations.
>
> Signed-off-by: Trevor Woerner <twoerner@xxxxxxxxx>
> ---
> arch/arm/boot/dts/ti/omap/am335x-pocketbeagle.dts | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/arch/arm/boot/dts/ti/omap/am335x-pocketbeagle.dts b/arch/arm/boot/dts/ti/omap/am335x-pocketbeagle.dts
> index e35d84ca5706..8042917b3b3b 100644
> --- a/arch/arm/boot/dts/ti/omap/am335x-pocketbeagle.dts
> +++ b/arch/arm/boot/dts/ti/omap/am335x-pocketbeagle.dts
> @@ -271,6 +271,16 @@ AM33XX_PADCONF(AM335X_PIN_GPMC_AD14, PIN_INPUT_PULLUP, MUX_MODE7)
> pinctrl-single,bias-pulldown = < 0x10 0x00 0x10 0x18>;
> };
>
> + /* P2_20 (ZCZ ball T13) gpio2_00 0x888 */
> + P2_20_gpio: P2-20-gpio-pins {
> + pinctrl-single,pins = <
> + AM33XX_PADCONF(AM335X_PIN_GPMC_CSN3, PIN_INPUT_PULLUP, MUX_MODE7)
> + >;
> + pinctrl-single,bias-pullup = < 0x10 0x10 0x00 0x18>;
> + pinctrl-single,bias-pulldown = < 0x10 0x00 0x10 0x18>;
> + };
> +
> +
> /* P2_10 (ZCZ ball R14) gpio1_20 0x850 PIN 20 */
> P2_10_gpio: P2-10-gpio-pins {
> pinctrl-single,pins = <
Thanks applying all four patches into omap-for-v6.7/dt. I left out the extra
line break above though.
Regards,
Tony
