Each interrupt should be in its own cell. This is much more readable.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
arch/arm/boot/dts/ti/davinci/da850.dtsi | 15 +++++----------
arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi | 10 +++++-----
arch/arm/boot/dts/ti/omap/am437x-l4.dtsi | 12 ++++++------
arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi | 6 +++---
4 files changed, 19 insertions(+), 24 deletions(-)
diff --git a/arch/arm/boot/dts/ti/davinci/da850.dtsi b/arch/arm/boot/dts/ti/davinci/da850.dtsi
index e46e4d22db39..afa6268a17d7 100644
--- a/arch/arm/boot/dts/ti/davinci/da850.dtsi
+++ b/arch/arm/boot/dts/ti/davinci/da850.dtsi
@@ -421,7 +421,7 @@ edma0: edma@0 {
/* eDMA3 CC0: 0x01c0 0000 - 0x01c0 7fff */
reg = <0x0 0x8000>;
reg-names = "edma3_cc";
- interrupts = <11 12>;
+ interrupts = <11>, <12>;
interrupt-names = "edma3_ccint", "edma3_ccerrint";
#dma-cells = <2>;
@@ -447,7 +447,7 @@ edma1: edma@230000 {
/* eDMA3 CC1: 0x01e3 0000 - 0x01e3 7fff */
reg = <0x230000 0x8000>;
reg-names = "edma3_cc";
- interrupts = <93 94>;
+ interrupts = <93>, <94>;
interrupt-names = "edma3_ccint", "edma3_ccerrint";
#dma-cells = <2>;
@@ -494,8 +494,7 @@ serial2: serial@10d000 {
rtc0: rtc@23000 {
compatible = "ti,da830-rtc";
reg = <0x23000 0x1000>;
- interrupts = <19
- 19>;
+ interrupts = <19>, <19>;
clocks = <&pll0_auxclk>;
clock-names = "int-clk";
status = "disabled";
@@ -725,11 +724,7 @@ eth0: ethernet@220000 {
ti,davinci-ctrl-ram-offset = <0>;
ti,davinci-ctrl-ram-size = <0x2000>;
local-mac-address = [ 00 00 00 00 00 00 ];
- interrupts = <33
- 34
- 35
- 36
- >;
+ interrupts = <33>, <34>, <35>,<36>;
clocks = <&psc1 5>;
power-domains = <&psc1 5>;
status = "disabled";
@@ -748,7 +743,7 @@ gpio: gpio@226000 {
gpio-controller;
#gpio-cells = <2>;
reg = <0x226000 0x1000>;
- interrupts = <42 43 44 45 46 47 48 49 50>;
+ interrupts = <42>, <43>, <44>, <45>, <46>, <47>, <48>, <49>, <50>;
ti,ngpio = <144>;
ti,davinci-gpio-unbanked = <0>;
clocks = <&psc1 3>;
diff --git a/arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi b/arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi
index 7e50fe633d8a..d6a143abae5f 100644
--- a/arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi
+++ b/arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi
@@ -455,8 +455,8 @@ target-module@3e000 { /* 0x44e3e000, ap 35 60.0 */
rtc: rtc@0 {
compatible = "ti,am3352-rtc", "ti,da830-rtc";
reg = <0x0 0x1000>;
- interrupts = <75
- 76>;
+ interrupts = <75>,
+ <76>;
};
};
@@ -739,7 +739,7 @@ mac: ethernet@0 {
* c0_tx_pend
* c0_misc_pend
*/
- interrupts = <40 41 42 43>;
+ interrupts = <40>, <41>, <42>, <43>;
ranges = <0 0 0x8000>;
syscon = <&scm_conf>;
status = "disabled";
@@ -779,7 +779,7 @@ mac_sw: switch@0 {
syscon = <&scm_conf>;
status = "disabled";
- interrupts = <40 41 42 43>;
+ interrupts = <40>, <41>, <42>, <43>;
interrupt-names = "rx_thresh", "rx", "tx", "misc";
ethernet-ports {
@@ -899,7 +899,7 @@ pruss_mii_rt: mii-rt@32000 {
pruss_intc: interrupt-controller@20000 {
compatible = "ti,pruss-intc";
reg = <0x20000 0x2000>;
- interrupts = <20 21 22 23 24 25 26 27>;
+ interrupts = <20>, <21>, <22>, <23>, <24>, <25>, <26>, <27>;
interrupt-names = "host_intr0", "host_intr1",
"host_intr2", "host_intr3",
"host_intr4", "host_intr5",
diff --git a/arch/arm/boot/dts/ti/omap/am437x-l4.dtsi b/arch/arm/boot/dts/ti/omap/am437x-l4.dtsi
index 415210b034ef..824b9415ebbe 100644
--- a/arch/arm/boot/dts/ti/omap/am437x-l4.dtsi
+++ b/arch/arm/boot/dts/ti/omap/am437x-l4.dtsi
@@ -442,8 +442,8 @@ rtc: rtc@0 {
compatible = "ti,am4372-rtc", "ti,am3352-rtc",
"ti,da830-rtc";
reg = <0x0 0x1000>;
- interrupts = <GIC_SPI 75 IRQ_TYPE_LEVEL_HIGH
- GIC_SPI 76 IRQ_TYPE_LEVEL_HIGH>;
+ interrupts = <GIC_SPI 75 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 76 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clk_32768_ck>;
clock-names = "int-clk";
system-power-controller;
@@ -549,10 +549,10 @@ mac_sw: switch@0 {
syscon = <&scm_conf>;
status = "disabled";
- interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH
- GIC_SPI 41 IRQ_TYPE_LEVEL_HIGH
- GIC_SPI 42 IRQ_TYPE_LEVEL_HIGH
- GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH>;
+ interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 41 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 42 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH>;
interrupt-names = "rx_thresh", "rx", "tx", "misc";
ethernet-ports {
diff --git a/arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi b/arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi
index 6f46f1ecf1e5..8946b5580cd9 100644
--- a/arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi
+++ b/arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi
@@ -415,9 +415,9 @@ rtc {
gpadc: gpadc {
compatible = "ti,palmas-gpadc";
- interrupts = <18 0
- 16 0
- 17 0>;
+ interrupts = <18 0>,
+ <16 0>,
+ <17 0>;
#io-channel-cells = <1>;
ti,channel0-current-microamp = <5>;
ti,channel3-current-microamp = <10>;
--
2.34.1
