* Drew Fustini <drew@xxxxxxxxxxxxxxx> [200914 10:44]:
> Document the values in pinctrl-single,pins when #pinctrl-cells = <2>
>
> Fixes: 27c90e5e48d0 ("ARM: dts: am33xx-l4: change #pinctrl-cells from 1 to 2")
> Reported-by: Trent Piepho <tpiepho@xxxxxxxxx>
> Link: https://lore.kernel.org/linux-omap/3139716.CMS8C0sQ7x@zen.local/
> Signed-off-by: Drew Fustini <drew@xxxxxxxxxxxxxxx>
Acked-by: Tony Lindgren <tony@xxxxxxxxxxx>
> ---
> .../bindings/pinctrl/pinctrl-single.txt | 20 ++++++++++++-------
> 1 file changed, 13 insertions(+), 7 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt
> index ba428d345a56..ef560afdd52e 100644
> --- a/Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt
> +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt
> @@ -96,16 +96,22 @@ pinctrl-single,bit-per-mux is set), and uses the common pinctrl bindings as
> specified in the pinctrl-bindings.txt document in this directory.
>
> The pin configuration nodes for pinctrl-single are specified as pinctrl
> -register offset and value pairs using pinctrl-single,pins. Only the bits
> -specified in pinctrl-single,function-mask are updated. For example, setting
> -a pin for a device could be done with:
> +register offset and values using pinctrl-single,pins. Only the bits specified
> +in pinctrl-single,function-mask are updated.
> +
> +When #pinctrl-cells = 1, then setting a pin for a device could be done with:
>
> pinctrl-single,pins = <0xdc 0x118>;
>
> -Where 0xdc is the offset from the pinctrl register base address for the
> -device pinctrl register, and 0x118 contains the desired value of the
> -pinctrl register. See the device example and static board pins example
> -below for more information.
> +Where 0xdc is the offset from the pinctrl register base address for the device
> +pinctrl register, and 0x118 contains the desired value of the pinctrl register.
> +
> +When #pinctrl-cells = 2, then setting a pin for a device could be done with:
> +
> + pinctrl-single,pins = <0xdc 0x30 0x07>;
> +
> +Where 0x30 is the pin configuration value and 0x07 is the pin mux mode value.
> +See the device example and static board pins example below for more information.
>
> In case when one register changes more than one pin's mux the
> pinctrl-single,bits need to be used which takes three parameters:
> --
> 2.25.1
>
