Add DT node for the new cpsw switchdev based driver.
Signed-off-by: Grygorii Strashko <grygorii.strashko@xxxxxx>
---
arch/arm/boot/dts/am437x-l4.dtsi | 54 ++++++++++++++++++++++++++++++++
1 file changed, 54 insertions(+)
diff --git a/arch/arm/boot/dts/am437x-l4.dtsi b/arch/arm/boot/dts/am437x-l4.dtsi
index 3d393fe252c6..e702e9576115 100644
--- a/arch/arm/boot/dts/am437x-l4.dtsi
+++ b/arch/arm/boot/dts/am437x-l4.dtsi
@@ -571,6 +571,60 @@
phys = <&phy_gmii_sel 2 0>;
};
};
+
+ mac_sw: switch@0 {
+ compatible = "ti,am4372-cpsw","ti,cpsw-switch";
+ reg = <0x0 0x4000>;
+ ranges = <0 0 0x4000>;
+ clocks = <&cpsw_125mhz_gclk>, <&dpll_clksel_mac_clk>;
+ clock-names = "fck", "50mclk";
+ assigned-clocks = <&dpll_clksel_mac_clk>;
+ assigned-clock-rates = <50000000>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ syscon = <&scm_conf>;
+ status = "disabled";
+
+ interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH
+ GIC_SPI 41 IRQ_TYPE_LEVEL_HIGH
+ GIC_SPI 42 IRQ_TYPE_LEVEL_HIGH
+ GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "rx_thresh", "rx", "tx", "misc";
+
+ ethernet-ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ cpsw_port1: port@1 {
+ reg = <1>;
+ label = "port1";
+ mac-address = [ 00 00 00 00 00 00 ];
+ phys = <&phy_gmii_sel 1 0>;
+ };
+
+ cpsw_port2: port@2 {
+ reg = <2>;
+ label = "port2";
+ mac-address = [ 00 00 00 00 00 00 ];
+ phys = <&phy_gmii_sel 2 0>;
+ };
+ };
+
+ davinci_mdio_sw: mdio@1000 {
+ compatible = "ti,am4372-mdio", "ti,cpsw-mdio","ti,davinci_mdio";
+ clocks = <&cpsw_125mhz_gclk>;
+ clock-names = "fck";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ bus_freq = <1000000>;
+ reg = <0x1000 0x100>;
+ };
+
+ cpts {
+ clocks = <&cpsw_cpts_rft_clk>;
+ clock-names = "cpts";
+ };
+ };
};
target-module@200000 { /* 0x4a200000, ap 7 02.0 */
--
2.17.1
