Add VPFE device nodes entries.
Add OmniVision OV2659 sensor device nodes and linkage.
The sensor clock (xvclk) is sourced from clkout1.
Add clock entries to properly select clkout1 and set its parent
clock to sys_clkin_ck.
Signed-off-by: Benoit Parrot <bparrot@xxxxxx>
---
arch/arm/boot/dts/am437x-sk-evm.dts | 27 ++++++++++++++++++++++++++-
1 file changed, 26 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/am437x-sk-evm.dts b/arch/arm/boot/dts/am437x-sk-evm.dts
index 74eaa6a3b258..25222497f828 100644
--- a/arch/arm/boot/dts/am437x-sk-evm.dts
+++ b/arch/arm/boot/dts/am437x-sk-evm.dts
@@ -272,6 +272,12 @@
>;
};
+ clkout1_pin: pinmux_clkout1_pin {
+ pinctrl-single,pins = <
+ 0x270 (PIN_OUTPUT_PULLDOWN | MUX_MODE3) /* XDMA_EVENT_INTR0/CLKOUT1 */
+ >;
+ };
+
cpsw_default: cpsw_default {
pinctrl-single,pins = <
/* Slave 1 */
@@ -593,6 +599,25 @@
pinctrl-0 = <&i2c1_pins>;
clock-frequency = <400000>;
+ ov2659@30 {
+ compatible = "ovti,ov2659";
+ reg = <0x30>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&clkout1_pin>;
+
+ clocks = <&clkout1_mux_ck>;
+ clock-names = "xvclk";
+ assigned-clocks = <&clkout1_mux_ck>;
+ assigned-clock-parents = <&clkout1_osc_div_ck>;
+
+ port {
+ ov2659_1: endpoint {
+ remote-endpoint = <&vpfe0_ep>;
+ link-frequencies = /bits/ 64 <70000000>;
+ };
+ };
+ };
+
edt-ft5306@38 {
status = "okay";
compatible = "edt,edt-ft5306", "edt,edt-ft5x06";
@@ -877,7 +902,7 @@
/* Camera port */
port {
vpfe0_ep: endpoint {
- /* remote-endpoint = <&sensor>; add once we have it */
+ remote-endpoint = <&ov2659_1>;
ti,am437x-vpfe-interface = <0>;
bus-width = <8>;
hsync-active = <0>;
--
2.17.1
