Add bindings for the new TI CPSW switch driver. Comparing to the legacy bindings (net/cpsw.txt): - ports definition follows DSA bindings (net/dsa/dsa.txt) and ports can be marked as "disabled" if not physically wired. - all deprecated properties dropped; - all legacy propertiies dropped which represent constant HW cpapbilities (cpdma_channels, ale_entries, bd_ram_size, mac_control, slaves, active_slave) - TI CPTS DT properties are reused as is, but grouped in "cpts" sub-node - TI Davinci MDIO DT bindings are reused as is, because Davinci MDIO is reused. Signed-off-by: Grygorii Strashko <grygorii.strashko@xxxxxx> --- .../bindings/net/ti,cpsw-switch.yaml | 240 ++++++++++++++++++ 1 file changed, 240 insertions(+) create mode 100644 Documentation/devicetree/bindings/net/ti,cpsw-switch.yaml diff --git a/Documentation/devicetree/bindings/net/ti,cpsw-switch.yaml b/Documentation/devicetree/bindings/net/ti,cpsw-switch.yaml new file mode 100644 index 000000000000..81ae8cafabc1 --- /dev/null +++ b/Documentation/devicetree/bindings/net/ti,cpsw-switch.yaml @@ -0,0 +1,240 @@ +# SPDX-License-Identifier: GPL-2.0 +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/net/ti,cpsw-switch.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: TI SoC Ethernet Switch Controller (CPSW) Device Tree Bindings + +maintainers: + - Grygorii Strashko <grygorii.strashko@xxxxxx> + - Sekhar Nori <nsekhar@xxxxxx> + +description: + The 3-port switch gigabit ethernet subsystem provides ethernet packet + communication and can be configured as an ethernet switch. It provides the + gigabit media independent interface (GMII),reduced gigabit media + independent interface (RGMII), reduced media independent interface (RMII), + the management data input output (MDIO) for physical layer device (PHY) + management. + +properties: + compatible: + oneOf: + - const: ti,cpsw-switch + - items: + - const: ti,am335x-cpsw-switch + - const: ti,cpsw-switch + - items: + - const: ti,am4372-cpsw-switch + - const: ti,cpsw-switch + - items: + - const: ti,dra7-cpsw-switch + - const: ti,cpsw-switch + + reg: + maxItems: 1 + description: + The physical base address and size of full the CPSW module IO range + + ranges: true + + clocks: + maxItems: 1 + description: CPSW functional clock + + clock-names: + maxItems: 1 + items: + - const: fck + + interrupts: + items: + - description: RX_THRESH interrupt + - description: RX interrupt + - description: TX interrupt + - description: MISC interrupt + + interrupt-names: + items: + - const: "rx_thresh" + - const: "rx" + - const: "tx" + - const: "misc" + + pinctrl-names: true + + syscon: + $ref: /schemas/types.yaml#definitions/phandle + description: + Phandle to the system control device node which provides access to + efuse IO range with MAC addresses + + + ethernet-ports: + type: object + properties: + '#address-cells': + const: 1 + '#size-cells': + const: 0 + + patternProperties: + "^port@[0-9]+$": + type: object + minItems: 1 + maxItems: 2 + description: CPSW external ports + + allOf: + - $ref: ethernet-controller.yaml# + + properties: + reg: + maxItems: 1 + enum: [1, 2] + description: CPSW port number + + phys: + $ref: /schemas/types.yaml#definitions/phandle-array + maxItems: 1 + description: phandle on phy-gmii-sel PHY + + label: + $ref: /schemas/types.yaml#/definitions/string-array + maxItems: 1 + description: label associated with this port + + ti,dual-emac-pvid: + $ref: /schemas/types.yaml#/definitions/uint32 + maxItems: 1 + minimum: 1 + maximum: 1024 + description: + Specifies default PORT VID to be used to segregate + ports. Default value - CPSW port number. + + required: + - reg + - phys + + mdio: + type: object + allOf: + - $ref: "ti,davinci-mdio.yaml#" + description: + CPSW MDIO bus. + + cpts: + type: object + description: + The Common Platform Time Sync (CPTS) module + + properties: + clocks: + maxItems: 1 + description: CPTS reference clock + + clock-names: + maxItems: 1 + items: + - const: cpts + + cpts_clock_mult: + $ref: /schemas/types.yaml#/definitions/uint32 + description: + Numerator to convert input clock ticks into ns + + cpts_clock_shift: + $ref: /schemas/types.yaml#/definitions/uint32 + description: + Denominator to convert input clock ticks into ns. + Mult and shift will be calculated basing on CPTS rftclk frequency if + both cpts_clock_shift and cpts_clock_mult properties are not provided. + + required: + - clocks + - clock-names + +required: + - compatible + - reg + - ranges + - clocks + - clock-names + - interrupts + - interrupt-names + - '#address-cells' + - '#size-cells' + +examples: + - | + #include <dt-bindings/interrupt-controller/irq.h> + #include <dt-bindings/interrupt-controller/arm-gic.h> + #include <dt-bindings/clock/dra7.h> + + mac_sw: switch@0 { + compatible = "ti,dra7-cpsw-switch","ti,cpsw-switch"; + reg = <0x0 0x4000>; + ranges = <0 0 0x4000>; + clocks = <&gmac_main_clk>; + clock-names = "fck"; + #address-cells = <1>; + #size-cells = <1>; + syscon = <&scm_conf>; + inctrl-names = "default", "sleep"; + + interrupts = <GIC_SPI 334 IRQ_TYPE_LEVEL_HIGH>, + <GIC_SPI 335 IRQ_TYPE_LEVEL_HIGH>, + <GIC_SPI 336 IRQ_TYPE_LEVEL_HIGH>, + <GIC_SPI 337 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "rx_thresh", "rx", "tx", "misc"; + + ethernet-ports { + #address-cells = <1>; + #size-cells = <0>; + + cpsw_port1: port@1 { + reg = <1>; + label = "port1"; + mac-address = [ 00 00 00 00 00 00 ]; + phys = <&phy_gmii_sel 1>; + phy-handle = <ðphy0_sw>; + phy-mode = "rgmii"; + ti,dual_emac_pvid = <1>; + }; + + cpsw_port2: port@2 { + reg = <2>; + label = "wan"; + mac-address = [ 00 00 00 00 00 00 ]; + phys = <&phy_gmii_sel 2>; + phy-handle = <ðphy1_sw>; + phy-mode = "rgmii"; + ti,dual_emac_pvid = <2>; + }; + }; + + davinci_mdio_sw: mdio@1000 { + compatible = "ti,cpsw-mdio","ti,davinci_mdio"; + reg = <0x1000 0x100>; + clocks = <&gmac_clkctrl DRA7_GMAC_GMAC_CLKCTRL 0>; + clock-names = "fck"; + #address-cells = <1>; + #size-cells = <0>; + bus_freq = <1000000>; + + ethphy0_sw: ethernet-phy@0 { + reg = <0>; + }; + + ethphy1_sw: ethernet-phy@1 { + reg = <1>; + }; + }; + + cpts { + clocks = <&gmac_clkctrl DRA7_GMAC_GMAC_CLKCTRL 25>; + clock-names = "cpts"; + }; + }; -- 2.17.1
