Pass irqflags to 8250 driver from zoom2 board file Zoom2 has IRQF_TRIGGER_RISING requirement for the 8250 GPIO irq This patch is dependent on 8250 driver changes getting accepted upstream: Refer: http://patchwork.kernel.org/patch/31884/ Signed-off-by: Vikram Pandita <vikram.pandita@xxxxxx> --- Warning: could cause compilation break if 8250 patch is not integrated first arch/arm/mach-omap2/board-zoom-debugboard.c | 2 ++ arch/arm/mach-omap2/serial.c | 2 +- 2 files changed, 3 insertions(+), 1 deletions(-) diff --git a/arch/arm/mach-omap2/board-zoom-debugboard.c b/arch/arm/mach-omap2/board-zoom-debugboard.c index bac5c43..f546063 100644 --- a/arch/arm/mach-omap2/board-zoom-debugboard.c +++ b/arch/arm/mach-omap2/board-zoom-debugboard.c @@ -12,6 +12,7 @@ #include <linux/gpio.h> #include <linux/serial_8250.h> #include <linux/smsc911x.h> +#include <linux/interrupt.h> #include <mach/gpmc.h> @@ -84,6 +85,7 @@ static struct plat_serial8250_port serial_platform_data[] = { .mapbase = 0x10000000, .irq = OMAP_GPIO_IRQ(102), .flags = UPF_BOOT_AUTOCONF|UPF_IOREMAP|UPF_SHARE_IRQ, + .irqflags = IRQF_SHARED | IRQF_TRIGGER_RISING, .iotype = UPIO_MEM, .regshift = 1, .uartclk = QUART_CLK, diff --git a/arch/arm/mach-omap2/serial.c b/arch/arm/mach-omap2/serial.c index b094c15..45d4884 100644 --- a/arch/arm/mach-omap2/serial.c +++ b/arch/arm/mach-omap2/serial.c @@ -429,7 +429,7 @@ static void omap_uart_idle_init(struct omap_uart_state *uart) omap_ctrl_writew(v, uart->padconf); } - p->flags |= UPF_SHARE_IRQ; + p->irqflags |= IRQF_SHARED; ret = request_irq(p->irq, omap_uart_interrupt, IRQF_SHARED, "serial idle", (void *)uart); WARN_ON(ret); -- 1.6.0.3.613.g9f8f13 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
