Hi,
* Adam Ford <aford173@xxxxxxxxx> [190828 15:01]:
> The datasheet for the AM3517 shows the RNG is connected to L4.
> It shows the module address for the RNG is 0x480A0000, and it
> matches the omap2.dtsi description. Since the driver can support
> omap2 and omap4, it seems reasonable to assume the omap3 would
> use the same core for the RNG.
>
> This RFC, mimics much of the omap2 hwmods on the OMAP3. It
> also adds the necessary clock for driving the RNG. Unfortunately,
> it appears non-functional. If anyone has any suggestions on how
> to finish the hwmod (or port it to the newer l4 device tree
> format), feedback is requested.
Yup I'll take the bait :) The patch below seems to do the trick
for me on dm3730 based on translating your patch to probe with
ti-sysc.
Not sure about 34xx, it seems we're missing rng_clk? Care
to give it a try and attempt simlar patches for 34xx and
3517?
At least I'm not needing the "ti,no-reset-on-init" property
that your patch has a comment for. Maybe that's needed on
some other omap3.
Oh and this needs to default to status = "disabled" for
HS devices like n900 as it needs to use the omap3-rom-rng.
Regards,
Tony
8< -----------------------
diff --git a/arch/arm/boot/dts/omap36xx.dtsi b/arch/arm/boot/dts/omap36xx.dtsi
--- a/arch/arm/boot/dts/omap36xx.dtsi
+++ b/arch/arm/boot/dts/omap36xx.dtsi
@@ -140,6 +140,29 @@
};
};
+ rng_target: target-module@480a0000 {
+ compatible = "ti,sysc-omap2", "ti,sysc";
+ reg = <0x480a003c 0x4>,
+ <0x480a0040 0x4>,
+ <0x480a0044 0x4>;
+ reg-names = "rev", "sysc", "syss";
+ ti,sysc-mask = <(SYSC_OMAP2_AUTOIDLE)>;
+ ti,sysc-sidle = <SYSC_IDLE_FORCE>,
+ <SYSC_IDLE_NO>;
+ ti,syss-mask = <1>;
+ clocks = <&rng_ick>;
+ clock-names = "ick";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0 0x480a0000 0x2000>;
+
+ rng: rng@0 {
+ compatible = "ti,omap2-rng";
+ reg = <0x0 0x2000>;
+ interrupts = <52>;
+ };
+ };
+
/*
* Note that the sysconfig register layout is a subset of the
* "ti,sysc-omap4" type register with just sidle and midle bits
