On 26.04.19 01:40, Andrew Lunn wrote:
>> +Required Sub-nodes:
>> +- ports : contains CPSW external ports descriptions
>> + Required properties:
>> + - #address-cells : Must be 1
>> + - #size-cells : Must be 0
>> + - reg : CPSW port number. Should be 1 or 2
>> + - phys : phandle on phy-gmii-sel PHY (see phy/ti-phy-gmii-sel.txt)
>> + - phy-mode : operation mode of the PHY interface [1]
>> + - phy-handle : phandle to a PHY on an MDIO bus [1]
>
>
>> + cpsw_port1: port@1 {
>> + reg = <1>;
>> + ti,label = "port1";
>> + /* Filled in by U-Boot */
>> + mac-address = [ 00 00 00 00 00 00 ];
>> + phys = <&phy_gmii_sel 1>;
>
> Hi Grygorii
>
> phy-mode and phy-handle are required, but missing from your example.
>
> Otherwise, this looks like a reasonable binding.
Yea. they configured in board files - will add.
Thanks.
--
Best regards,
grygorii
