On Fri, Mar 29, 2019 at 01:13:10PM -0500, Andrew F. Davis wrote: > The correct DT property for specifying a GPIO used for reset > is "reset-gpios", the driver now accepts this name, use it here. > > Note the GPIO polarity in the driver was ignored before and always > assumed to be active low, when all the DTs are fixed we will start > respecting the specified polarity. Switch polarity in DT to the > currently assumed one, this way when the driver changes the > behavior will not change. > > Signed-off-by: Andrew F. Davis <afd@xxxxxx> I fixed up the prefix to use board name, and applied patch #1 ~ #3. Shawn
