Hi Ivan, On 2/26/19 10:45 AM, Ivan Khoronzhuk wrote: > One of the reasons of this proposition is safety and performance - > host should not receive traffic which is not designated for it. > > Some network devices can hold separate address tables for vlans and > real device, but for some reason there is no possibility to apply it > with generic net addressing scheme easily. At this moment the fastest > solution is to add mcast/ucast entries for every created vlan > including real device. But it not only consumes forwarding table but > also adds holes in the filtering and thus wastes cpus cycles. > > This patchseries tries to correct core to assign mcast and ucast > addresses only for vlans that really require it and as result an end > driver can exclusively and simply set its rx filters. As an example > it's implemented on cpsw TI driver, but generic changes provided by > this series can be reused by other ethernet drivers having similar > rx filter address possibilities. > > An address+vid is considered as separate address. The reserved device > address length is 32 Bytes, for ethernet devices it's additional > opportunity to pass auxiliary address info, like virtual ID > identifying a device the address belongs to. This series makes it > possible at least for ETH_P_8021Q. > > Thus end real device can setup separate tables for virtual devices > just retrieving VID from the address. A device address space can > maintain addresses and references on them separately for each virtual > device if it needs so, or only addresses for real device (and all its > vlans) it holds usually. > > A vlan device can be in any place of device chain upper real device, > say smth like rdevice/bonding/vlan or even rdevice/macvlan/vlan. > > This series is verified on TI am572x EVM that can hold separate tables > for vlans. Potentially it can be easily extended to netcp driver for > keystone 2 boards (including k2g) and also new am6 chipsets. As a > simple test case, different combinations of vlan+macvlan, macvlan+vlan > were used and tested as with unicast as multicast addresses. > > Based on net-next/master Thanks a lot for posting this patch series, I will take a look later tonight. > > It's continuation of RFC: > > [RFC PATCH net-next 0/5] net: allow hw addresses for virtual device > https://lkml.org/lkml/2018/12/3/817 > > Ivan Khoronzhuk (6): > net: core: dev_addr_lists: add VID to device address > net: 8021q: vlan_dev: add vid tag to addresses of uc and mc lists > net: 8021q: vlan_dev: add vid tag for vlan device own address > ethernet: eth: add default vid len for all ehternet kind devices > net: ethernet: ti: cpsw: update mc filtering to use IVDF > net: ethernet: ti: cpsw: add macvlan and ucast/vlan filtering support > > drivers/net/ethernet/ti/Kconfig | 1 + > drivers/net/ethernet/ti/cpsw.c | 139 ++++++++++++-------------------- > include/linux/if_vlan.h | 2 + > include/linux/netdevice.h | 4 + > net/8021q/Kconfig | 12 +++ > net/8021q/vlan.c | 3 + > net/8021q/vlan.h | 2 + > net/8021q/vlan_core.c | 25 ++++++ > net/8021q/vlan_dev.c | 103 ++++++++++++++++++----- > net/core/dev_addr_lists.c | 124 ++++++++++++++++++++++------ > net/ethernet/eth.c | 10 ++- > 11 files changed, 292 insertions(+), 133 deletions(-) > -- Florian
