Hi, On Fri, Dec 21, 2018 at 03:27:57PM -0600, Adam Ford wrote: > I pulled the current 'master' from Linus' tree, and noticed that there > seems to be an MMC error during boot. > > [ 4.120239] VUSB3V1: disabling > [ 4.131256] Waiting for root device /dev/mmcblk1p2... > [ 4.157470] mmc2: new high speed SDIO card at address 0001 > [ 5.354827] mmc1: card never left busy state > [ 5.359283] mmc1: error -110 whilst initialising SD card > > It's at this point, i need to eject the card, and re-insert it in > order to continue. > > [ 9.513244] mmc1: host does not support reading read-only switch, > assuming write-enable > [ 9.525329] mmc1: new high speed SDHC card at address e624 > [ 9.536315] mmcblk1: mmc1:e624 SS04G 3.69 GiB > [ 9.562469] mmcblk1: p1 p2 > [ 9.637451] EXT4-fs (mmcblk1p2): mounted filesystem with ordered > data mode. Opts: (null) > [ 9.646240] VFS: Mounted root (ext4 filesystem) on device 179:2. > > It then carries on just fine. > > I went back to 4.19, and it's just fine, so something happened. > Before I bisect, I was curious to see if anyone had seen this already. > I don't want to duplicate an effort, but 4.20 is right around the > corner. Could be different issue (I'm not seeing any error messages), but on N900 the external MMC card is not getting probed. :-( Only the internal one works. v4.19 works OK. A.
