Hi Andrew,
On 10/08/2018 07:50 PM, Andrew Lunn wrote:
>> /* Configure GMII_SEL register */
>> - cpsw_phy_sel(cpsw->dev, slave->phy->interface, slave->slave_num);
>> + if (!IS_ERR(slave->data->ifphy))
>> + phy_set_netif_mode(slave->data->ifphy, slave->data->phy_if);
>
> Is slave->data->phy_if also passed to phy_connect()? So you are going
> to end up with both the MAC and the PHY inserting RGMII delays, and it
> not working.
No. This logic not changed comparing to how it was.
* "rgmii" (RX and TX delays are added by the MAC when required)
rgmii_id = 0 --> CPSW: 0 : Internal Delay, PHY - no delay
* "rgmii-id" (RGMII with internal RX and TX delays provided by the PHY, the
MAC should not add the RX or TX delays in this case)
* "rgmii-rxid" (RGMII with internal RX delay provided by the PHY, the MAC
should not add an RX delay in this case)
* "rgmii-txid" (RGMII with internal TX delay provided by the PHY, the MAC
should not add an TX delay in this case)
rgmii_id = 1 --> CPSW: 1 : No Internal Delay, PHY/board - delay
>
> You need to somehow decide if the MAC is going to do the delay, or the
> PHY. But not both.
Again, this series does not change logic - only interfaces and DT.
Thank you for review.
--
regards,
-grygorii
