Remove support for the LM3697 LED device
from the ti-lmu. The LM3697 will be supported
via a stand alone LED driver.
Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
---
.../devicetree/bindings/mfd/ti-lmu.txt | 26 +------------------
1 file changed, 1 insertion(+), 25 deletions(-)
diff --git a/Documentation/devicetree/bindings/mfd/ti-lmu.txt b/Documentation/devicetree/bindings/mfd/ti-lmu.txt
index c885cf89b8ce..920f910be4e9 100644
--- a/Documentation/devicetree/bindings/mfd/ti-lmu.txt
+++ b/Documentation/devicetree/bindings/mfd/ti-lmu.txt
@@ -9,7 +9,6 @@ TI LMU driver supports lighting devices below.
LM3632 Backlight and regulator
LM3633 Backlight, LED and fault monitor
LM3695 Backlight
- LM3697 Backlight and fault monitor
Required properties:
- compatible: Should be one of:
@@ -18,11 +17,10 @@ Required properties:
"ti,lm3632"
"ti,lm3633"
"ti,lm3695"
- "ti,lm3697"
- reg: I2C slave address.
0x11 for LM3632
0x29 for LM3631
- 0x36 for LM3633, LM3697
+ 0x36 for LM3633
0x38 for LM3532
0x63 for LM3695
@@ -38,7 +36,6 @@ Optional nodes:
Required properties:
- compatible: Should be one of:
"ti,lm3633-fault-monitor"
- "ti,lm3697-fault-monitor"
- leds: LED properties for LM3633. Please refer to [2].
- regulators: Regulator properties for LM3631 and LM3632.
Please refer to [3].
@@ -220,24 +217,3 @@ lm3695@63 {
};
};
};
-
-lm3697@36 {
- compatible = "ti,lm3697";
- reg = <0x36>;
-
- enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>;
-
- backlight {
- compatible = "ti,lm3697-backlight";
-
- lcd {
- led-sources = <0 1 2>;
- ramp-up-msec = <200>;
- ramp-down-msec = <200>;
- };
- };
-
- fault-monitor {
- compatible = "ti,lm3697-fault-monitor";
- };
-};
--
2.19.0
