* Tony Lindgren <tony@xxxxxxxxxxx> [180522 15:03]:
> * Reizer, Eyal <eyalr@xxxxxx> [180522 14:07]:
> > > > >
> > > > > OK try replacing the pm_runtime_put_noidle() above with just
> > > > > pm_runtime_put_sync(). The reason why I put noidle there was the
> > > > > wlcore_fw_sleep() call, with that gone put_sync should do the trick.
> > > > >
> > > >
> > > > I have tried that already. Same problem. The last call to:
> > > > ret = wlcore_raw_write32(wl, HW_ACCESS_ELP_CTRL_REG, ELPCTRL_SLEEP)
> > > >
> > > > which allows the firmware to get into ELP state during wowlan suspend is
> > > > only completing after system resume for some unknown reason...
> > >
> > > Hmm maybe try also adding wl1271_power_off(wl) after put_sync()?
> > >
> >
> > No, we don't want to power off the chip in wowlan mode.
> > We power it of only during standard suspend.
> >
> > The trick is that it stays on during suspend and can be used
> > As a wakeup source to the host on specific packets received by
> > The firmware over the air.
>
> Oh right, then in theory pm_runtime_put_sync() should do the
> here.
OK got my beaglebone green wireless to wake from suspend to UART
after doing:
# echo N > /sys/module/printk/parameters/console_suspend
No idea why that is needed.. Not needed on beaglebone black here.
Here's a modified version of your patch, does that put wlcore to
idle with wowlan during suspend for you?
Regards,
Tony
8< ------------------------------
diff --git a/drivers/net/wireless/ti/wlcore/main.c b/drivers/net/wireless/ti/wlcore/main.c
--- a/drivers/net/wireless/ti/wlcore/main.c
+++ b/drivers/net/wireless/ti/wlcore/main.c
@@ -998,24 +998,6 @@ static int wlcore_fw_wakeup(struct wl1271 *wl)
return wlcore_raw_write32(wl, HW_ACCESS_ELP_CTRL_REG, ELPCTRL_WAKE_UP);
}
-static int wlcore_fw_sleep(struct wl1271 *wl)
-{
- int ret;
-
- mutex_lock(&wl->mutex);
- ret = wlcore_raw_write32(wl, HW_ACCESS_ELP_CTRL_REG, ELPCTRL_SLEEP);
- if (ret < 0) {
- wl12xx_queue_recovery_work(wl);
- goto out;
- }
- set_bit(WL1271_FLAG_IN_ELP, &wl->flags);
-out:
- mutex_unlock(&wl->mutex);
- mdelay(WL1271_SUSPEND_SLEEP);
-
- return 0;
-}
-
static int wl1271_setup(struct wl1271 *wl)
{
wl->raw_fw_status = kzalloc(wl->fw_status_len, GFP_KERNEL);
@@ -1738,6 +1720,7 @@ static int __maybe_unused wl1271_op_suspend(struct ieee80211_hw *hw,
{
struct wl1271 *wl = hw->priv;
struct wl12xx_vif *wlvif;
+ unsigned long flags;
int ret;
wl1271_debug(DEBUG_MAC80211, "mac80211 suspend wow=%d", !!wow);
@@ -1785,7 +1768,6 @@ static int __maybe_unused wl1271_op_suspend(struct ieee80211_hw *hw,
goto out_sleep;
out_sleep:
- pm_runtime_put_noidle(wl->dev);
mutex_unlock(&wl->mutex);
if (ret < 0) {
@@ -1795,20 +1777,6 @@ static int __maybe_unused wl1271_op_suspend(struct ieee80211_hw *hw,
/* flush any remaining work */
wl1271_debug(DEBUG_MAC80211, "flushing remaining works");
-
- /*
- * disable and re-enable interrupts in order to flush
- * the threaded_irq
- */
- wlcore_disable_interrupts(wl);
-
- /*
- * set suspended flag to avoid triggering a new threaded_irq
- * work. no need for spinlock as interrupts are disabled.
- */
- set_bit(WL1271_FLAG_SUSPENDED, &wl->flags);
-
- wlcore_enable_interrupts(wl);
flush_work(&wl->tx_work);
/*
@@ -1817,14 +1785,16 @@ static int __maybe_unused wl1271_op_suspend(struct ieee80211_hw *hw,
*/
cancel_delayed_work(&wl->tx_watchdog_work);
+
/*
- * Use an immediate call for allowing the firmware to go into power
- * save during suspend.
- * Using a workque for this last write was only hapenning on resume
- * leaving the firmware with power save disabled during suspend,
- * while consuming full power during wowlan suspend.
+ * set suspended flag to avoid triggering a new threaded_irq
+ * work.
*/
- wlcore_fw_sleep(wl);
+ spin_lock_irqsave(&wl->wl_lock, flags);
+ set_bit(WL1271_FLAG_SUSPENDED, &wl->flags);
+ spin_unlock_irqrestore(&wl->wl_lock, flags);
+
+ pm_runtime_put_sync(wl->dev);
return 0;
}
--
2.17.0
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
