According to AM335x TRM[1] 14.3.6.2, AM437x TRM[2] 15.3.6.2 and DRA7 TRM[3] 24.11.4.8.7.3.3, in-band mode in EXT_EN(bit18) register is only available when PHY is configured in RGMII mode with 10Mbps speed. It will cause some networking issues without RGMII mode, such as carrier sense errors and low throughput. TI also mentioned this issue in their forum[4]. This patch adds the check mechanism for PHY interface with RGMII interface type, the in-band mode can only be set in RGMII mode with 10Mbps speed. References: [1]: https://www.ti.com/lit/ug/spruh73p/spruh73p.pdf [2]: http://www.ti.com/lit/ug/spruhl7h/spruhl7h.pdf [3]: http://www.ti.com/lit/ug/spruic2b/spruic2b.pdf [4]: https://e2e.ti.com/support/arm/sitara_arm/f/791/p/640765/2392155 Suggested-by: Holsety Chen (陳憲輝) <Holsety.Chen@xxxxxxxx> Signed-off-by: SZ Lin (林上智) <sz.lin@xxxxxxxx> Signed-off-by: Schuyler Patton <spatton@xxxxxx> --- Changes from v1: - Use phy_interface_is_rgmii helper function - Remove blank line drivers/net/ethernet/ti/cpsw.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/net/ethernet/ti/cpsw.c b/drivers/net/ethernet/ti/cpsw.c index 1b1b78fdc138..b2b30c9df037 100644 --- a/drivers/net/ethernet/ti/cpsw.c +++ b/drivers/net/ethernet/ti/cpsw.c @@ -1014,7 +1014,8 @@ static void _cpsw_adjust_link(struct cpsw_slave *slave, /* set speed_in input in case RMII mode is used in 100Mbps */ if (phy->speed == 100) mac_control |= BIT(15); - else if (phy->speed == 10) + /* in band mode only works in 10Mbps RGMII mode */ + else if ((phy->speed == 10) && phy_interface_is_rgmii(phy)) mac_control |= BIT(18); /* In Band mode */ if (priv->rx_pause) -- 2.16.2 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
