These are needed to use the n_gsm driver for TS 27.010 UART
multiplexing. Note that support for the OOB wake gpio is still
missing so the UART is not yet usable for n_gsm.
Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx>
---
arch/arm/boot/dts/omap4-droid4-xt894.dts | 33 ++++++++++++++++++++++++++++++++
1 file changed, 33 insertions(+)
diff --git a/arch/arm/boot/dts/omap4-droid4-xt894.dts b/arch/arm/boot/dts/omap4-droid4-xt894.dts
--- a/arch/arm/boot/dts/omap4-droid4-xt894.dts
+++ b/arch/arm/boot/dts/omap4-droid4-xt894.dts
@@ -557,6 +557,28 @@
>;
};
+ /*
+ * Note that the v3.0.8 stock userspace dynamically remuxes uart1
+ * rts pin probably for PM purposes to PIN_INPUT_PULLUP | MUX_MODE7
+ * when not used. If needed, we can add rts pin remux later based
+ * on power measurements.
+ */
+ uart1_pins: pinmux_uart1_pins {
+ pinctrl-single,pins = <
+ /* 0x4a10013c mcspi1_cs2.uart1_cts ag23 */
+ OMAP4_IOPAD(0x13c, PIN_INPUT_PULLUP | MUX_MODE1)
+
+ /* 0x4a10013e mcspi1_cs3.uart1_rts ah23 */
+ OMAP4_IOPAD(0x13e, MUX_MODE1)
+
+ /* 0x4a100140 uart3_cts_rctx.uart1_tx f27 */
+ OMAP4_IOPAD(0x140, PIN_OUTPUT | MUX_MODE1)
+
+ /* 0x4a1001ca dpm_emu14.uart1_rx aa3 */
+ OMAP4_IOPAD(0x1ca, PIN_INPUT_PULLUP | MUX_MODE2)
+ >;
+ };
+
/* uart3_tx_irtx and uart3_rx_irrx */
uart3_pins: pinmux_uart3_pins {
pinctrl-single,pins = <
@@ -626,6 +648,17 @@
};
};
+/*
+ * As uart1 is wired to mdm6600 with rts and cts, we can use the cts pin for
+ * uart1 wakeirq.
+ */
+&uart1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart1_pins>;
+ interrupts-extended = <&wakeupgen GIC_SPI 72 IRQ_TYPE_LEVEL_HIGH
+ &omap4_pmx_core 0xfc>;
+};
+
&uart3 {
interrupts-extended = <&wakeupgen GIC_SPI 74 IRQ_TYPE_LEVEL_HIGH
&omap4_pmx_core 0x17c>;
--
2.16.2
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
